Owner's Manual

177
3 Setting Noise ReductionN
Cautions for Setting Multi Shot Noise Reduction
If there is significant misalignment in the image due to camera shake, the
noise reduction effect may be minimal.
If you are handholding the camera, keep it steady to prevent camera
shake. Using a tripod is recommended.
If you shoot a moving subject, the moving subject may leave
afterimages.
The image alignment may not function properly with repetitive patterns
(lattice, stripes, etc.) or flat, single-tone images.
If the subject’s brightness changes as the four consecutive shots are
taken, irregular exposure in the image may result.
Recording the image to the card will take longer than with normal
shooting. During the processing of the images, “buSY” will be displayed
in the viewfinder and on the LCD panel, and you cannot take another
picture until the processing is completed.
You cannot use AEB and WB bracketing.
The [Distortion] setting will be set automatically to [Disable].
If [z3: Long exp. noise reduction], [z3: Multiple exposure], [z3:
HDR Mode], AEB, or WB bracketing is set, [Multi Shot Noise
Reduction] cannot be set.
Flash shooting is not possible. The AF-assist beam will be emitted
according to the [23: AF-assist beam firing] setting.
You cannot set [Multi Shot Noise Reduction] for bulb exposures and
movie shooting.
The setting will automatically switch to [Standard] if you do any of the
following: Turn the power switch to <2>, change the battery, replace
the card, select the <A> or <F> shooting mode, set or switch the
image-recording quality to RAW or RAW+JPEG, or switch to movie
shooting.
COPY