Owner's Manual

Caution
If the “30"” shutter speed and the lowest aperture value blink, it indicates
underexposure.
Increase the ISO speed or use flash.
If the “1/8000” shutter speed and the highest aperture value blink, it indicates
overexposure.
Lower the ISO speed or use an ND filter (sold separately) to reduce the amount of
light entering the lens.
Note
Differences between < > and < > modes
In < > mode, many functions, such as the AF method and metering mode, are
set automatically to prevent spoiled shots. The functions you can set are limited.
On the other hand, with < > mode, only the shutter speed and aperture value are
set automatically. You can freely set the AF method, metering mode, and other
functions.
Program shift
In < > mode, you can freely change the combination (program) of shutter speed
and aperture value set automatically by the camera while maintaining the same
exposure. This is called Program shift.
With Program shift, you can press the shutter button halfway, then turn the < >
dial until the desired shutter speed or aperture value is displayed.
Program shift will be canceled automatically when the metering timer ends
(exposure setting display turns off).
Program shift cannot be used with flash.
100