Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Basic Network Settings
- Preparation
- Displaying the Connection Wizard
- Checking the Type of Access Point
- Connecting via WPS (PBC Mode)
- Connecting via WPS (PIN Mode)
- Connecting to a Detected Network Manually
- Connecting to a Network Manually
- Connecting Using an Infrastructure
- Connecting in Camera Access Point Mode
- Setting the IP Address
- Configuring Settings for the Communication Function
- Transferring Images to an FTP Server
- Operating Remotely Using EOS Utility
- Operating the Camera Using Browser Remote
- Linked Shooting
- Synchronizing the Camera Time
- Terminating the Connection and Reconnecting
- Checking and Configuring Network Settings
- Troubleshooting
- Reference
- Trademarks
- Quick Start Guide
- Warranty
Connecting with a Manual Connection
The network settings for the camera access point mode are configured manually. Set
[SSID], [Channel setting], and [Encryption settings] on each screen displayed.
1.
Select [Manual connection].
Select [OK] to proceed to the next screen.
2.
Enter the SSID (network name).
Press < > to display the virtual keyboard ( ), then enter the SSID.
After entering the SSID, press the < > button.
Select [OK] to proceed to the next screen.
3.
Select the desired channel setting.
To specify the settings manually, select [Manual setting], then select
the setting by using < >.
Select [OK] to establish a connection with the access point.
42