Owner's Manual

Table Of Contents
Installing and Removing the Card
42
1
Open the cover.
Set the power switch to <2>.
Check that the access lamp is off,
then open the cover.
If [Recording...] is displayed, close
the cover.
2
Remove the card.
Gently push in the card, then let it go
to eject.
Pull the card straight out, then close
the cover.
Removing the Card
The number of possible shots varies depending on the remaining
capacity of the card, image-recording quality, ISO speed, etc.
Setting [z1: Release shutter without card] to [Disable] will prevent
you from shooting without a card, forgetting to install it (p.324).
Access lamp