EN
Thank-you for choosing a Candy washing machine. We are confident it will loyally assist you in safely washing your clothes, even delicates, day after day. Environmental conditions This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used).
l This appliances is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments. A different use of this appliance from household environment or from typical housekeeping functions, as commercial use by expert or trained users, is excluded even in the above applications.
l Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the washer dryer. WARNING: never stop a washer dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.
consult the product technical specification please refer to the manufacturer website. Electrical connections safety instructions WARNING: water may reach very high temperatures during the wash cycle. and l Do not expose the washing machine to rain, direct sunlight or other weather elements. Protect from possible freezing.
2. INSTALLATION l Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. l If the washing machine is built-in, unscrew the 3 or 4 transportation screws (A) and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
Hydraulic connections 3 EN l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do not reuse old hose-sets). l Some models may include one or more of the following features: l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water tap and the red one to the hot water tap.
l Level the appliance using the feet as 8 illustrated in figure 8: a. turn the nut clockwise to release the screw; b. rotate the foot to raise or lower it until it touches to the floor; c. lock the foot, screwing in the nut, until it tightens against to the bottom of the washing machine. l Plug in the appliance. A B WARNING: contact the Customer Service Centre should the power cord need replacement.
Load tips WARNING: when sorting laundry, make sure: Before using a drying (WASHER-DRYERS) - have eliminated metallic objects such as hair clips, pins, coins, from laundry; l SAVE energy and time by selecting a programme high spin speed to reduce the water content in laundry before using a drying programme. - to have buttoned pillow cases, closed zips, tied loose belts and long robe ribbons; Following is a quick guide with tips and recommendations on detergent use at the various temperatures.
l Remove and clean the filter; when 4. MAINTENANCE AND CLEANING To clean the washing machine exterior, use a damp cloth, avoiding abrasives, alcohol and/or solvents. To maintain a good wash performance we recommend that the soap drawer and pump filters are regularly cleaned. A monthly service wash, using a proprietary cleaner is also recommended. finished, replace it turning it clockwise. The filter handle will be locked when it is not possible to turn any further and the handle is horizontal.
5. PORTHOLE EMERGENCY OPENING EN Should the porthole be locked due to power shortage or as a result of a fault, it can be opened according to the following emergency unlocking procedure: 1. Disconnect the machine from the power socket. 2. Ensure that the water level is below the porthole before opening it, to prevent any flooding. Otherwise, drain excess water through the drain tube and collect it in a bucket. 3. Take out the detergent compartment (fig. 1). 4.
6. WI-FI This appliance is equipped with Wi-Fi technology that allows you to control it remotely via App, thanks to Wi-Fi function. Get all the details of the Wi-Fi functions by browsing the App in DEMO mode. l Open the App, create the user profile and MACHINE ENROLLMENT (ON APP) enroll the appliance following the instructions on the device display or the "Quick Guide" attached on the machine. l Download the Candy simply-Fi App on your device.
8. CONTROLS AND PROGRAMS This washing machine automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in washing times. Program selection l Turn on the appliance and select the required program. l Adjust the washing settings if necessary and select the required options.
SMART RING (ring for selecting PROGRAMMES/OPTIONS) WARNING: Do not touch the display while fitting the plug, because during the initial seconds, the machine performs a self-calibration that might be interrupted: if this occurs, the machine may not operate properly. In this case, remove the plug and repeat the operation. l After turning the appliance on, rotating the "SMART RING" the icons for the programmes will light up and the display will show the description and the relevant parameters.
To prevent damage to the fabrics, it is not possible to increase the temperature above the maximum value set for each programme. CYCLE DURATION - SPIN l When a programme is selected the display automatically shows the cycle duration, which can vary, depending on the options selected. l By this option you can reduce the maximum spin speed for the set programme, until it is completely excluded.
l Press START/PAUSE to start the counting at the end of which the programme will automatically start. l Press the "SET" button to select through l The delay start can be cancelled, pressing l Confirm by pressing the "SET" button the ON/OFF button for about 2 seconds, until the display switches off. - STEAM l By this option you can add a specific steam treatment to some washing cycles (see programme table).
automatically upgraded to the new length of the programme and the NON compatible ones will be cancelled. The previously set temperature and spin levels will not be exceeded to safeguard the fabrics and for getting the best washing result in a shorter time. In order to ensure the correct operation of the appliance, it is advisable not to interrupt the drying phase unless it is absolutely necessary. l Press START/PAUSE to start washing.
Table of programmes 1) 2) (MAX.) 2 1 (see control panel) PROGRAMME Standard* Standard* Standard* (MAX.
When this phase has terminated, switch off the appliance, add the rest of the fabrics and proceed with a normal wash on the most suitable programme. 2) When a program is selected, on the display is shown the recommended wash temperature that can be reduced (where allowed) by setting the TEMPERATURE option through the "SET" button. However it’s not possible to increase this option beyond the maximum value given. INFORMATION FOR THE LABORATORIES (Ref.
Programmes selection To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). COTTON STRONG Made to have a perfect washing. The final spin at maximum speed gives more efficient removal. COTTON This program is suitable to clean normally soiled cotton laundry and it is the most efficient program in terms of combined energy and water consumptions for washing cotton laundry.
and avoid possible felting. It’s suggested to reverse clothing before drying. Timing is related to the amount of the washing and the spin speed selected for the wash. The cycle is suitable for small loads up to 1 kg (3 sweaters). WARNING: Dispensers used for concentrated powders and liquid detergents must be removed from the drum before commencing the tumble drying programmes. The drum changes direction during the drying cycle to prevent the laundry from tangling and producing even more drying.
9. DRYING CYCLE The correct way to dry l Drying guidance advice is general, but practical experience of using the product will help you to achieve the best drying results. l We recommend setting a lower drying time than indicated, when first using the appliance in order to establish the degree of dryness required. l We recommend not drying fabrics that fray easily, such as rugs or garments with a deep pile, in order to avoid air duct clogging.
the discharge correctly. hose is During the drying phase the drum will accelerate to a higher speed to distribute the load and to optimize the drying performance. positioned In order to ensure the correct operation of the appliance, it is advisable not to interrupt the drying phase unless it is absolutely necessary. WARNING: Do not dry articles with special padding (e.g. quilts, quilted anoraks, etc.) and very delicate fabrics. If garments are drip/dry, load less items to prevent creasing.
10. THROUBLESHOOTING AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. ERROR CODE FORMAT l Models with a display: the error is shown by a number preceded by the letter “E” (example: E2 = Error 2). l Models without display: an error is shown by a sequence of flashes of every LED.
Problem Possible causes and practical solutions The washing machine does not work / start The washing machine does not spin Make sure the product is plugged into a working supply socket. Make sure power is on. Make sure the wall socket is working, testing it with another appliance such as a lamp. The door may not be correctly closed: open and close it again. Check whether the required program was correctly selected and the start button pressed.
The use of ecological detergents without phosphates may cause the following effects: Warranty The product is guaranteed under the terms and conditions stated on the certificate included with the product. The warranty certificate must be duly filled in and stored, so as to be shown to the Authorised Customer Service Centre in case of need. Proof of purchase must be made available at the time of any warranty related repair.
Parameter Specifications (Wi-Fi) Specifications (Bluetooth) Wireless Standard 802.11 b/g/n Bluetooth v4.2 Frequency range 2,412 GHz. - 2,484 GHz. 2,412 GHz. - 2,484 GHz. 802.11b, DSSS 1 Mbps = +19.5 dBm Basic data Rate: RF Transmit Power (Typ): +4 dBm 802.11b, CCK 11 Mbps = +18.5 dBm Max Trasmit Power 802.11g, OFDM 54 Mbps = +18.5 dBm 802.11n, MCS7 = +14 dBm 802.11b = 1024 bytes, -80 dBm 802.11g = 1024 bytes, Minimum Receiving Sensivity -70 dBm 802.11n = 1024 bytes, -65 dBm 802.
- WD Bianca - 17.