EN
Thank you for choosing this product. We are proud to offer the ideal product for you and the best complete range of home appliances for your daily routine. WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials.
l This appliance is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments. A different use of this appliance from household environment or from typical housekeeping functions, as commercial use by expert or trained users, is excluded even in the above applications.
l Items such as foam rubber (latex foam), shower caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the washer dryer. WARNING: never stop a washer dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.
consult the product technical l Do not pull on the power cord specification please refer to the or appliance to unplug the manufacturer website. machine. Electrical connections safety instructions l Make sure there is no water in the drum before opening the door. and l The technical details (supply voltage and power input) are indicated on the product rating plate WARNING: water may reach very high temperatures during the wash cycle.
2. INSTALLATION l Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. l If the washing machine is built-in, unscrew the 3 or 4 transportation screws (A) and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
Hydraulic connections EN 3 l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do not reuse old hose-sets). l SOME MODELS may include one or more of the following features: 4 l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water tap and the red one to the hot water tap.
Setting 7 l The washing machine should be installed in its final position such that the water fill hose is not kinked or trapped. The corrugated drain hose should be inserted into suitable drain pipe of between 50 cm and 85 cm height above the floor using the curved drain hose support. If an under sink connection is used the drain hose must be routed above the sink overfill opening to prevent back siphoning. Care must be taken to avoid kinking or trapping the drain hose (fig. 7).
The detergent draw is split into compartments as illustrated in figure 9: 3 EN 3. DETERGENT DRAWER 9 l compartment "1": for prewash detergent; l compartment “ ”: for special additives, 1 softeners, starch fragrances, etc.; 2 WARNING: only use liquid products; the washing machine is set to automatically dose additives at each cycle during the last rinse. l compartment "2": for 10 washing detergent. A liquid detergent cup is also included IN SOME MODELS (fig. 10).
Maximise the load size 4. PRACTICAL HINTS l Achieve the best use of energy, water, Load tips When sorting laundry, make sure: - have eliminated metallic objects such as hair clips, pins, coins, from laundry; - to have buttoned pillow cases, closed zips, tied loose belts and long robe ribbons; - to have removed rollers, hooks or clips from curtains; - to have carefully read clothing washing labels; - to have removed any persistent stains using specific detergents.
- cloudier rinse drain water: This effect is tied to the suspended zeolites which do not have negative effects on rinse efficiency. For washes between 40°C and 60°C the type of detergent used needs to be appropriate for the type of fabric and level of soiling. Normal powders are suitable for “white” or colour fast fabrics with high soiling, while liquid detergents or “colour protecting” powders are suitable for coloured fabrics with light levels of soiling.
l Fill the drawer with hot water. 5. CLEANING AND MAINTENANCE Looking after your appliance correctly can extend its lifespan. Cleaning the appliance’s exterior l Disconnect the machine from the power supply. l Clean the appliance’s external cabinet, using a damp cloth and AVOIDING ABRASIVES, ALCOHOL AND/OR DILUENTS. Drawer cleaning l It is advisable to regularly clean the detergent drawer to avoid the accumulation of detergent and additive residues.
S u g g e s tio n s fo r m o v e s o r prolonged disuse l The appliance has a special filter that traps larger residues that could block the draining system, such as buttons or coins (depending on the model, consider version A or B). We recommend checking and cleaning the filter 5 or 6 times a year. l Disconnect the machine from the power supply. l Ensure all the water has been emptied from the drum.
6. QUICK USER GUIDE This washing machine automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in washing times. 7. CONTROLS AND PROGRAMS Q A Program selection l Turn on the washing machine and select the required program. l Adjust the washing temperature if necessary and press the required "option" buttons.
When the START/PAUSE button has been pressed, the appliance can take few seconds before it starts working. When the programme selector is turned the display lights up to show the settings for the programme selected. For energy saving, at the end of the cycle or with an inactivity period, the display level contrast will decrease.
- Press the delay start button once to activate it (h00 appears on the display) and then press it again to set a 1 hour delay (h01 appears on the display). The pre-set delay increases by 1 hour each time the button is pressed, until h24 appears on the display, at which point pressing the button again will reset the delay start to zero. - Confirm by pressing the START/PAUSE button. The delay countdown will begin and when it has finished the programme will start automatically.
To prevent damage to the fabrics, it is not possible to increase the speed over the maximum allowed for the programme. This button allows you to choose between two different options, depending on the selected programme: - RAPID l To reactivate the spin cycle press the button until you reach the spin speed you would like to set. The button becomes active when you select the RAPID (14'/30'/44') programme on the knob and allows you to select one of three durations indicated.
3) DOOR LOCKED INDICATOR LIGHT Digital Display The display’s indicator system allows you to be constantly informed about the status of the machine. 1 2 34 6 l The indicator light is illuminated when the door is fully closed. Close the door BEFORE selecting the START/PAUSE button. 7 l When START/PAUSE is pressed on the machine with the door closed, the indicator will flash momentarily and then illuminate.
6) WASH TEMPERATURE LIGHTS - recognises the presence of too much soap suds, and if necessary, adjust the amount of rinse water. This shows the washing temperature of the selected programme that can be changed (where allowed) by the relevant button. If you want carry out a cold wash all the indicators must be off. - adjusts the spin speed according to the load, thus avoiding any imbalance.
l Smart Care – Smart Check-up and Auto- SMART TOUCH Clean cycles and a troubleshooting guide. This appliance is equipped with Smart Touch technology that allows you to interact, via the App, with smartphones based on Android operating system and equipped with NFC (Near Field Communication) function. l Download on your smartphone Candy simply-Fi App. the The Candy simply-Fi App is available for devices running both Android and iOS, both for tablets and for smartphones.
If you do not know the position of your NFC antenna, slightly move the smartphone in a circular motion over the Smart Touch logo until the App confirms the connection. In order for the data transfer to be successful, it is essential TO KEEP THE SMARTPHONE ON THE DASHBOARD DURING THESE FEW SECONDS OF THE PROCEDURE; a message on the device will inform about the correct outcome of the operation and advise you when it is possible to move the smartphone away.
Table of programmes 1) (MAX.) * PROGRAMME 2 (see control panel) (MAX.
INFORMATION FOR THE TEST LABORATORIES STANDARD PROGRAMMES ACCORDING TO Directive 96/60/CE (Only for models with liquid detergent compartment) When only a limited number of articles have stains which require treatment with liquid bleaching agents, preliminary removal of stain can be carried out in the washing machine. Pour the bleach into the liquid bleach container, inserted into the compartment marked "2" in the detergent drawer, and set the special programme RINSE.
Description of programmes To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). Choose programme in accordance with the laundry instructions appearing on labels, especially the maximum recommended temperature.
EN Delicates This programme has reduced periods of drum rotation during the cycle and is particularly suitable or washing delicate fabrics. The wash cycle and rinses are carried out with a high level of water to ensure the best performance.
8. DRYING CYCLE The correct way to dry l Drying guidance advice is general, but practical experience of using the product will help you to achieve the best drying results. l We recommend setting a lower drying time than indicated, when first using the appliance in order to establish the degree of dryness required. l We recommend not drying fabrics that fray easily, such as rugs or garments with a deep pile, in order to avoid air duct clogging.
l Switch off the machine by turning the By selecting the wool drying programme, it's not possible to select a degree of dryness different from the default one. l Open the door and remove the laundry. l Turn off the tap. l The washer dryer will calculate the time CANCELLING THE DRYING PROGRAMME needed for drying and the level of moisture remaining in the laundry, according to the load and drying type selected.
l At the end of the wash phase the display 9. AUTOMATIC WASHING/ DRYING CYCLE will show the drying time remaining. l When the programme is finished the word You cannot exceed the maximum dryable load of laundry indicated in the programme table, otherwise the laundry will not be dried satisfactory. "End" will appear on the display. After 5 minutes the appliance will go into standby mode (on certain models, the display will show two lines).
If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. FOR SMART TOUCH MODELS The Candy simply-Fi app has a Smart Check-up function that allows you to confirm the functionality and status of the product at any time. To use the Candy simply-Fi app you will need an Android smartphone with NFC technology. More info can be found on the App.
OTHER ANOMALIES Problem Possible causes and practical solutions The washing machine does not work / start The washing machine does not spin Make sure the product is plugged into a working supply socket. Make sure power is on. Make sure the wall socket is working, testing it with another appliance such as a lamp. The door may not be correctly closed: open and close it again. Check whether the required program was correctly selected and the start button pressed.
Warranty The product is guaranteed under the terms and conditions stated on the certificate included with the product. The certificate has to be stored so as to be shown to the Authorized Customer Service Centre in case of need. You can also check the warranty conditions on our web site. To obtain assistance, please fill in the form on-line or contact us at the number indicated on the support page of our web site.
- CSW T E - 20.04 - 43035426 - IDM s.r.l.