Manualshelf

Installation Sheet

ManualsBrandsCanarm ManualsLightingLED, Surface Mount Disk 11" Wide Integrated LED Outdoor Flush Mount Ceiling Fixture / Wall Sconce
1234
INSTALLATION INSTRUCTIONS
LED Surface Mount Downlight
FOR LED-SM11DL ,LED-SM15DL SERIES
Components
Important Safety Information
Please read these instructions carefully before attempting to install
WARNING:
Risk of fire. Use only on 120 volt 60Hz circuits. Suitable for wet
this product. It is advisable to keep these instructions in a safe place locations. Before installing your lighting fixture, thoroughly review enclosed
for further reference. install
ation manual.
WARNING:
All electrical connections must be in accordance with local and
CAUTION:
TURN OFF THE MAIN POWER AT THE CIRCUIT BREAKER
National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper BEFORE INSTALLING THE FIXTURE, IN ORDER TO PREVENT POSSIBLE
electrical wiring connections obtain the services of a qualified electrician. SHOCK.
WARNING:
RISK OF SHOCK electric current can cause painful
This
fixture is designed for use in a circuit protected by a fuse or circuit breaker.
shock or serious injury unless It is also designed to be installed in accordance with local electrical codes. If you
are unsure about your wiring, consult a qualified electrician or local electrical
A. Turn off the power Supply at the fuse or circuit breaker box before you inspector, and check your local electrical code.
install the
fixture.
WARNING:
RISK OF CUTS Some metal parts in the fixture may have sharp
B. Ground the fixture to avoid potential electric shocks and to ensure edges. To prevent cuts and scrapes, wear gloves when handlin
g the parts.
reliable starting.
CAUTION:
FOR WET LOCATION INSTALLATION ON UNEVEN SURFACE,
C. Double-check all connections to be sure they are tight and correct. ADD GASKET OR CAULKING COMPOUND ON BACK OF FIXTURE FO
R SEAL
AGAINST MOUNTING SURFACE.
D. Wear rubber soled shoes and work on a sturdy wooden ladder.
Maintenance & Care
1. Ensure that the power is disconnected prior to cleaning.
2. To keep the finish of this product, wipe over with soft cloth periodically.
3. Do not use harsh chemical solvents, it may dis-color or damage the finish.
Preparation for Installation
1. Read these instructions carefully before attempting to install this product.
2. Disconnect e
lectrical power before installing or servicing any part of this fixture.
3. Place fixture on a clean flat surface.
LED Surface Mount Light
1 x Installation Instructions
Hardware Kit
Page 1
Made in China

Summary of content (4 pages)