California Air Tools PRO 1006 Composite Orbital Sander Model No.
Technical Data Sanding Pad………………………………………………………………………..6” Free speed…………………………………………………………………………10,000 rpm Air consumption…...……………………………………………………………….2.8 cfm (79.2 l/min) Operating pressure………………………………………………………………..90 psi (6.3 bar) Air inlet size…………………………………………………………………………1/4” Air hose size………………………………………………………………………..3/8” Weight………………………………………………………………………………2.50Lbs A-Weighted sound pressure level………………………………………………..89.0 dB (A) Sound power level…………………………………………………………………100.
Air supply 1. Ensure tool air valve (or trigger) is in the “off” position before connecting to the air supply. 2. You will require 90 PSI of air pressure 2.8 CFM of air flow. 3. WARNING! Ensure the air supply is clean and does not exceed 8bar (120psi) while operating the sander. Too high air pressure and unclean air will shorten the product life due to excessive wear, and may be dangerous causing damage and/or personal injury. 4. Drain the air tank daily. Water in the air line will damage the machine. 5.
1. As a standard practice, drain water from the air compressor tank and air lines prior to use each day (reference your compressor operators manual for detailed instructions). 2. Install a 1/4” male connector (not included) into the air inlet port on the tool. 3. Turn on the air compressor and allow it to build up pressure. 4. To assemble the backing disks and sandpaper. 5. Adjust the air compressor’s regulator or the supply line regulator to 90PSI. 6. Connect the tool to the air hose quick coupler. 7.
PROBLEMS POSSIBLE CAUSES REMEDIES Tool runs at normal speed but loses under load ■. Motor parts worn. ■ Cam clutch worn or sticking due to lack of lubricant. ■ Tool runs slowly. Air flows slightly from exhaust ■ Motor parts jammed with dirt particles ■ Power regulator in closed position ■ Air flow blocked by dirt. ■ Tools will not run. Air flows freely from exhaust ■ One or more motor vanes stuck due to material build up.
Exploding view Spare part list No. Description NO Description No. Description No. Description 1 Rubber Grip 14 Cylinder Front Plate 27 Bolt M4×10 40 Regulator 2 Housing 15 Gasket 28 Jacket 41 Pin 2×19 3 Bolt M5×0.8×4.3 16 Bearing Washer 29 Sanding Pad 42 Bolt 4 Washer 17 Washer 30 Trigger 43 O-ring 16.5×1.
Limited Warranty This Warranty is Limited to CALIFORNIA AIR TOOLS and SPRAYIT Products. Limited Warranty: 1 Year CALIFORNIA AIR TOOLS, Inc. will repair or replace, free of charge, to the original retail customer whom purchased a CALIFORNIA AIR TOOLS or SPRAYIT product from an authorized dealer, distributor or distributor’s dealer. This warranty does not transfer to subsequent owners. CALIFORNIA AIR TOOLS, Inc.
