cork Installation Guide (888) 788-2254 CaliFloors.
The Collection Flooring Systems Wide+ Click 11-5/8” Wide Plank Dims: 35-5/8” x 11-5/8” x 7/16” Flooring Accessories Quarter Round Reducer T-Molding Threshold Stair Nosing - Overlap Stair Tread CALI Cork Flooring Installation Guide Questions? (888) 788-2254 CaliFloors.
Pre-Installation Before you begin installation, remember to P.A.C.E. yourself with the checklist below. Full installation instructions and maintenance guidelines can also be found online at CaliFloors.com PA C E PREPARE THE SUBFLOOR Use 6mil Plastic on Concrete PA C E ACCLIMATE FLOORING Acclimate Your Cork Flooring For 2 to 3 Days Make sure the subfloor is flat, level, clean and free of debris. New concrete must be cured for at least 60 days.
Pre-Installation Prepare Job Site, Acclimation, Control Subfloor Moisture, Environmental Conditions Proper installation and maintenance are key elements in achieving best flooring results. It is the responsibility of the installer/owner to follow all guidelines provided by CALI for success. Please read through this document completely, additional installation materials such as videos, illustrations and more can also be found at CaliFloors.com.
Pre-Installation Prior to Installation of CALI Flooring Job Site Preparation Prior to installation, inspect planks in daylight for visible faults/damage. Check if subfloor/site conditions comply with the specifications described in these instructions. If you are not satisfied do not install, and contact your supplier. CALI is not responsible for flooring that is installed with visible defects. Before laying: Measure the room at a right angle to the direction of the planks.
Acceptable Subfloor Thickness Requirements: Joist System Spacing (Inches on Center) Minimum Thickness 12” 5/8” 12” to 16” 3/4” 16” to 19.2” 7/8” 19.3 to 24” 1-1/8” Pre-Installation Wood Subfloors: Wood Subfloors must be securely fastened. A best practice is to nail or screw every 6” along joists to avoid squeaking. If leveling is needed, sand down high spots and fill in low spots with a Portland based leveling compound.
Installation Floating Installation Method Recommended Tools for Cork Installation • • • • Pencil Tapping block (required) Hammer Chalk Line • • • • 3/8” spacers Utility Knife Table Saw Rubber Mallet • • • Double Sided Prybar Miter Saw Tape Measure Installing the First Row 1. Starting from the right with the tongue-side facing the wall, carefully place the first board in place, using spacers to leave a expansion gap between wall and edges of the plank. 2.
Installation Next Steps: 1. If the cut plank is at least 12” in length, it can be used as a starter piece in your next row. When laying the next row and future rows, make sure that there is at least 8” between the plank end joints on adjacent rows. Avoid an “H” pattern by varying the size of your starter piece. For a natural look rows and patterns should be staggered. 2.
Installation Care & Maintenance Guidelines General Care • For general cleaning, dry or damp mop as needed using Bona Stone Tile & Laminate Floor Cleaner or something similar • Never use a steam mop or wet-mop as standing water may cause permanent damage and the heat from the steam mop may dull the finish. The moisture from the dampened mop should evaporate off the floor quickly. • Although Cali Cork is water resistant, it is still a best practice to avoid excess moisture on the floor.
Installation Frequently Asked Questions How do I fix a scratch on my finish? For deeper scratches or gouges, plank replacement is recommended. How can I remove a stain? When removing stains, always begin at the outer edge of the stain and work toward the middle. Occasional Flooring Noise Floor noise is normal and will vary from one installation type to the next.
