Installation Guide

ManualsBrandsCafe ManualsAppliances24" Built in Microwave Drawer Oven - Stainless Steel

Table Of Contents

Quick Guide

CWL112P2RS1

CWL112P2RW5

CWL112P2RD5

For a full manual in English and Spanish visit

Para un manual completo en inglés y español

cafeappliances.com/literature

Thank You! ... for your purchase of a Café brand appliance.

cafeappliances.com/register

Timely product registration will allow for enhanced communication and prompt service under the terms of your warranty,

should the need arise. You may also mail in the pre-printed registration card included in the packing material.

Drawer Microwave

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT — Save these instructions for local inspector’s use.

IMPORTANT — Observe all governing codes and ordinances.

• Note to Installer — Be sure to leave these instructions with the Consumer.

•

Note to Consumer — Keep these instructions

with your Owner’s Manual for future reference.

• Skill Level — Installation of this appliance requires basic mechanical and electrical skills.

• Proper installation is the responsibility of the installer. Product failure due to improper installation is not covered

under the warranty. See Owner’s Manual for warranty information.

IMPORTANT

Use this oven only for its intended purpose. Never use the oven for warming or heating a room.

Prolonged use of the oven without proper ventilation can be hazardous.

WARNING

If the information in this manual is not followed exactly, a fire or electrical shock may result that

could cause property damage, personal injury or death.

WARNING

To reduce the risk of tipping, the Drawer Microwave must be secured by a properly installed Anti-

Tip block.

• This Drawer Microwave must be electrically grounded in accordance with local codes.

• Make sure the wall coverings and the cabinets around the Drawer Microwave can withstand the heat generated by

the Drawer Microwave.

WARNING

Never leave children alone or unattended in the area where a Drawer Microwave is in use.

Never leave the drawer open when the microwave is unattended.

READ AND SAVE THESE INSTRUCTIONS

31-7000166 Rev. 0 07-21 GEA

IMPORTANT SAFETY INFORMATION

READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE

Summary of content (16 pages)

PAGE 1
Quick Guide CWL112P2RS1 CWL112P2RW5 CWL112P2RD5 Drawer Microwave Thank You! ... for your purchase of a Café brand appliance. Register Your Appliance: Register your new appliance online at your convenience! cafeappliances.com/register Timely product registration will allow for enhanced communication and prompt service under the terms of your warranty, should the need arise. You may also mail in the pre-printed registration card included in the packing material.
PAGE 2
Installation Instructions WARNING Stepping, leaning or sitting on the drawer may result in serious injuries and can also cause damage to the Drawer Microwave. •D o not use the Drawer Microwave as a storage space. This creates a potentially hazardous situation. • Check that the time-of-day is in the display. If not, touch Stop/Clear to prevent unintended use. UNPACK DRAWER MICROWAVE Remove all packing materials from inside the Drawer Microwave.
PAGE 3
Installation Instructions 24” DRAWER MICROWAVE MEASUREMENTS •F igures 1 and 2 contain many drawer microwave measurements for reference when planning the drawer location. •T his drawer microwave can be installed below any electric or gas wall oven or under selected cook top models. •C an also be installed using an electrical outlet in an adjacent cabinet within the areas where the provided electrical cord can reach.
PAGE 4
Installation Instructions DRAWER INSTALLATION ELECTRIC OUTLET The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected electrical supply. It is recommended that a separate circuit serving only this appliance be provided. The drawer is equipped with a 3-prong grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded. Should you only have a 2-prong outlet, have a qualified electrician install a correct wall receptacle.
PAGE 5
Flush Mount Installation Instructions IMPORTANT NOTES TO THE INSTALLER PARTS INCLUDED •R ead all of the Installation Manual that is included with the Drawer Microwave before installing in the flush mount configuration. •O bserve all governing codes, ordinances, and safety instructions. •B e sure to leave these installation instructions with the consumer. Qty Description 1 Flush Mount Deflector Vent 2 Mounting Screws 1. Prepare cabinet opening as shown in Figures 6, 7, 8, and 9.
PAGE 6
Flush Mount Installation Instructions 1. Prepare cabinet opening as shown in Figures 6, 7, 8, and 9 (cont). Figure 7 Anti-Tip Block Mounting Cleat Drawer Face 22” mounting cleat opening width /” 1 8 11/2” Cabinet Face NOTE: the mounting surface of the finished cleat must sit 1-1/2” back from the face of the cabinet (pushing the face of the drawer out 1/8”). For ¼”, the cleat must sit 1-3/8”. CL Top View Move oven location downward for extended countertops for better viewing angle.
PAGE 7
Flush Mount Installation Instructions 2. Install deflector as shown in Figures 10 and 11 Shelf detail showing the deflector vent during installation. Position deflector vent and mark holes. Pre drill using a 1/16” bit before mounting. Figure 10 7. W hen you are sure the cord is out of the way, slide the drawer ¾ way back into the opening. Remove the string by pulling on one end of the loop. 8. Slide the drawer all the way back until the mounting flanges touch the cleats in the cabinet opening. 9.
PAGE 8
31-7000166 Rev.
PAGE 9
Guía de Instalación Rápida CWL112P2RS1 CWL112P2RW5 CWL112P2RD5 Microondas de Cajón ¡Gracias! ... por la compra de un electrodoméstico de la marca Café Registre su electrodoméstico: ¡Registre su nuevo electrodoméstico en línea cuando lo desee! cafeappliances.com/register El registro oportuno del producto permitirá una mejor comunicación y un servicio rápido bajo los términos de su garantía, en caso de que surja la necesidad.
PAGE 10
Instrucciones de Instalación ADVERTENCIA Pararse, apoyarse o sentarse sobre el cajón puede producir lesiones graves y también puede ocasionar daños sobre el Microondas de Cajón. •N o use el Microondas de Cajón como espacio de almacenamiento. Esto crea una situación potencialmente riesgosa. •C ontrole que aparezca la hora del día en la pantalla. De no ser así, presione Stop/Clear (Detener/ Borrar) para evitar un uso no intencional.
PAGE 11
Instrucciones de Instalación MEDIDAS DEL MICROONDAS DE CAJÓN DE 24” •L as figuras 1 y 2 contienen muchas medidas para microondas de cajón, como referencia para planificar la ubicación del cajón. • Este microondas de cajón puede ser instalado debajo de cualquier horno de pared eléctrico o a gas o debajo de modelos de superficies de cocción seleccionadas.
PAGE 12
Instrucciones de Instalación TOMACORRIENTE ELÉCTRICO Los requisitos eléctricos son contar con un suministro eléctrico protegido de 120 voltios, 60 Hz, CA únicamente, 15 amperes o más. Se recomienda contar con un circuito separado que se use únicamente con este electrodoméstico. El cajón está equipado con un enchufe de 3 clavijas conectado a tierra. Deberá estar enchufado a un receptáculo de pared que esté correctamente instalado y conectado a tierra.
PAGE 13
Montaje al Ras Instrucciones de Instalación NOTAS IMPORTANTES PARA EL INSTALADOR •L ea todo el Manual de Instalación incluido con el Microondas de Cajón, antes de instalar la configuración del montaje al ras. •C umpla con todos los códigos, ordenanzas e instrucciones de seguridad. •A segúrese de que el consumidor cuente con estas instrucciones. PIEZAS INCLUIDAS Cant Descripción 1 Ventilación con Deflector con Montaje al Ras 2 Tornillos de Montaje 1.
PAGE 14
Montaje al Ras Instrucciones de Instalación 1. Prepare la abertura del gabinete como se muestra en las Figuras 6, 7, 8 y 9. Figura 7 Bloque Antivolcaduras Taco de Montaje Cara del Cajón Ancho de la abertura del taco de montaje de 22” /” 1 8 11/2” Cara del Gabinete NOTA: La superficie de montaje del ristrel terminado se deberá volver a apoyar a 1 ½” desde la cara del gabinete (empujando la cara del cajón 1/8” hacia afuera). Para ¼”, el ristrel se deberá apoyar 1 3/8”.
PAGE 15
Montaje al Ras Instrucciones de Instalación 2. I nstale el deflector como se muestra en las Figuras 10 y 11. Detalle de la repisa donde se muestra la ventilación del deflector durante la instalación. Posicione la ventilación del deflector y marque los agujeros. Realice marcas usando una broca de 1/16” antes de realizar el montaje. Figura 10 7. C uando esté seguro de que el cable se encuentra fuera del recorrido, deslice el cajón hacia atrás ¾ del recorrido en la abertura.
PAGE 16
8 31-7000166 Rev.