User`s manual

8. Unscrew the Ground wire screw and
r re. emove the Ground wi
9 screws on both sides of . Loosen hexagonal
RS-232 port.
10. Remove Standard Back Panel and change
it with Ethernet Back Panel.
11. Tighten the hexagonal screws.
1
2
12. Secure the Ethernet module onto the
bracket.
13. Plug one end of the Module Connection
Wire into the socket on mainboard. Then
the figure showed to keep the
connector in place.
place the other end of Module Connection
Wire connector among the electric
capacities as
14. Align the Ethernet module to the Eth
port and plac
ernet
e the module upon the
mainboard.
【 Note 】
Please arrange the Module Connection Wire to
keep it away from the hole which is marked with
circle in figure.
15. Tighten the Ethernet Module screw and
Ground wire screw to secure the Ethernet
Module on the mainboard.
EZ-DT-2/EZ-DT-4 User’s Manual
21