Owner's manual

• Small phillips head screw driver • Needle-nose pliers

• Flat metal tool with smooth edges (like a butter knife) • Soft cloth

1. Using the small phillips-head

screw driver, remove the two

screws from the bottom of

the CC Witness / Witness+

Take care

not to loose the

screws

2. Open the cover to the SD

Card slot and, using both

thumbs, separate the case

by 1/8 inch.

Replacing the lithium-ion battery in the CC Witness / Witness+ is a moderately technical

process. If you are unsure of your ability to replace the battery yourself, please contact

C. Crane for assistance by calling 800-522-8863. A replacement battery can be ordered

from C. Crane for $14.95, or C. Crane will replace the battery for you at $34.95.

(Includes return shipping.)

WARNING: REPAIR AT YOUR OWN RISK. ANY DAMAGE INCURRED TO THE

CC WITNESS/ WITNESS + WILL NOT BE COVERED UNDER WARRANTY.

Do-It-Yourself Battery Replacement Guide

Tools Needed:

Please read instructions carefully and follow each step in order until completion.

PAGE 1
/ Do-It-Yourself Battery Replacement Guide Replacing the lithium-ion battery in the CC Witness / Witness+ is a moderately technical process. If you are unsure of your ability to replace the battery yourself, please contact C. Crane for assistance by calling 800-522-8863. A replacement battery can be ordered from C. Crane for $14.95, or C. Crane will replace the battery for you at $34.95. (Includes return shipping.) WARNING: REPAIR AT YOUR OWN RISK.
PAGE 2
4. Slide the tool around to the while bottom of th keeping the tool 1/16 inch into the separation. Continue this same technique while rounding all the edges of the case.
PAGE 3
7. Remove the old battery, along with the tape. 8. Before laying the unit facedown on a surface, first lay down a soft cloth to avoid potential damage to the display screen. Using a pair of needle nose pliers, remove the connector by gently pulling it towards the bottom of the case. Be careful not to put extreme pressure on the plastic connector with the pliers or you may damage it. 9. Insert the new battery in the same fashion.
PAGE 4
11. Using both hands, gently apply pressure to the back cover until the case is fully clipped together. 12. Reinsert the two screws … and you are done! ccrane.com/witness 800-522-8863 Copyright © 2013 by C. Crane Company, Inc. All rights reserved. No part of this manual may be reproduced, in any form or means whatsoever, without permission in writing from C. Crane Company, Inc.