Specifications

Remote Control Application
40
Remote application connection screen
NET/LAN PORT
The DSPXtreme is equipped with a NET/LAN port for ease of remote control, setup and monitoring.
CONTROL OF THE DSPXtreme BY THE NET/LAN PORT
If you wish to use the NET/LAN port to control the DSPXtreme follow the steps below
1. Connect a cat 5 cable to the RJ45 port on the DSPXtreme and plug this into your network hub/switch. A Xover
cable can be used to connect directly to a PC if you don’t have a switch or hub.
2. . Navigate to the ‘REMOTE SOURCE’ parameter contained in the system menu on the DSPXtreme and select
the Network option.
3. Run the DSPXtreme remote application and you will be presented with a connection screen (see below) .
Select the Ethernet option.
4. A password needs to be entered, regardless of password settings on the DSPXtreme itself. A password still
needs to be entered even if the passwords on the DSPXtreme have been disabled.
5. Click connect on the application and you should receive a ‘please wait’ box while the information is retrieved
from the DSPXtreme. Once connected you are then free to control the DSPXtreme with the remote application.
Further information on the remote application is contained on the following pages. If the DSPXtreme remote
application does not connect or disconnects after a few seconds then it could be that the password is incorrect.
The default password for the DSPXtreme is 3779. You are free to change these on the DSPXtreme itself (see
information on password control elsewhere in this manual)
PASSWORD ACCESS
The DSPXtreme contains two levels of password control, a high level password which blocks access to all areas
of the DSPXtreme and an ‘Output’ level password that allows access to all areas of the DSPXtreme except the
output menus that contain the output mode and level settings. The ‘Output’ level password could be given to pro-
gramme controllers to adjust the processing knowing that the transmission will remain compliant as there is no
way for the user to adjust the peak output level of the DSPXtreme.
These passwords can only be set from the DSPXtreme front panel and are located in the system menu.
The password box is located on the connection screen to the right of host and port input boxes.
The default (factory shipped) passwords for the two locks are ‘3779’. The remote application will always default
to this when it is run, unless you change it. Some users may find the output lock set to ‘0000’ Try this is 3779
does not let you access the output menus.