Instructions / Assembly

ManualsBrandsBuyers Products Company ManualsAutomotive96 Gloss Black Steel Full Size Top Mount Truck Tool Box

www.buyersproducts.com

Phone (440) 974-8888

Fax 800-841-8003

Installation Instructions

Topsider Toolbox

DANGER

Do not use this toolbox for storing or transporting flammables,

explosives, hazardous waste, gasoline, solvents, propane

tanks, acetylene tanks or cutting torches. This product is only

intended and safe for storing and transporting small tools and

equipment. Any modifications or unintended use of this toolbox

could create a hazardous condition that could result in death or

serious personal injury or property damage.

To prevent rust touch up any drilled holes with aerosol

paint. To prevent leaks, seal drilled holes with a silicone

sealant around the fasteners.

1. Park the vehicle on a level surface.

2. Turn the toolbox over and at each end of the box mark a line

about 6" long, about 1" inside of and parallel to the end of the

box. Mark 2 more lines centered in the box 12" apart. See figure

3. Place the mounting pad in position on the top of the truck

fender as shown in Figure 2. You may want to tape the pad to

the fender to keep it from moving during installation.

4. Place the toolbox in position on top of the truck bed and

support the rear of the box so the box can sit safely by itself.

Support the box with scrap lumber or similar material. Level the

box so it is horizontal when viewed from the rear.

Fasten the support legs directly to the truck floor and not

to any bed liner or floor mat.

CAUTION

To keep foreign materials out of your eyes when working,

drilling or checking the underside of the vehicle, always wear

protective eyewear.

Before you begin installing:

1. Read and understand these instructions

completely.

2. Verify that you have received all the parts

listed in the bill of materials.

Tools Required:

• (2) 1/2" Open or Boxed End Wrench

• Ratchet Wrench with 1/2" Deep Well Socket

• Electric Drill

• 1/2" and 3/8" Drill Bits

• Carpenters Square

• Utility Knife or Scissors

• Tape

• 9/16" Open or Boxed End Wrench

—continued

Summary of content (2 pages)

PAGE 1
www.buyersproducts.com Phone (440) 974-8888 Fax 800-841-8003 Installation Instructions Topsider Toolbox Tools Required: • (2) 1/2" Open or Boxed End Wrench Before you begin installing: 1. Read and understand these instructions completely. 2. Verify that you have received all the parts listed in the bill of materials. • Ratchet Wrench with 1/2" Deep Well Socket • Electric Drill • 1/2" and 3/8" Drill Bits To prevent rust touch up any drilled holes with aerosol paint.
PAGE 2
www.buyersproducts.com Phone (440) 974-8888 Fax 800-841-8003 5. Place one support leg as close to the rear corner of the box as possible and use a square to get proper vertical alignment. The closer the legs are mounted to the rear of the box, the more stable the box will be. The foot of each of the support legs must be squarely mounted on or between the floor ribs. 6. Mark both leg foot holes on the floor of the truck bed and both leg top holes on the end of the toolbox. 7.