Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Secure the side marker light to the outer fl are with
8-32 screw, 8-32 nut, and washer using a #2 Phillips
bit and a 11/32” socket with 8” extension (2 places).
NOTE: If you are having trouble putting the washer
and nut on the screw, use needle nose pliers.
37
Before installing the outer fl are, make sure that the
speed clips on the inner pieces are centered over
the predrilled holes.
38
Position the supplied side marker light onto the outer
fl are piece, threading the wires through the center
predrilled hole.
36
Seal heat shrink tubing on wire using a heat gun.
35
Use wire strippers to strip away approximately 3/8” of
wire covering from the factory installed side marker
lamp wires.
33
Install a Female Bullet Connector to the end of each
factory side marker light wire and secure by pressing
fi rmly with a wire crimp.
34