Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Step 4 Using a 1/2” socket wrench and a 1/2”
wrench, tighten all bolts until inner piece is snug
against fender. Do not overtighten: see step 21.
Inner piece should rest along upper style line
of sheet metal radius and not below it: see step
22.
Secure inner piece D8 (and P8 for passenger side
installation) to the sheet metal using the following
2 STEPS: Step 1 Position inner piece on fender,
aligning with existing factory hole in sheet metal.
73
74
Upper Style Line
Step 2 While holding the inner piece in place, install
a plastic push retainer in the rearward three hole
locations.
71
Step 3 Slide a .700” Washer onto 5/16” Hex Head
Bolt. Insert a bolt/washer assembly through inner
fl are piece and fender in frontward two locations and
secure with 5/16” Nylok Nut. Start the bolts but do
not tighten.
72
Step 2 While holding the inner piece in place, install
a plastic push retainer in each hole location. Inner
piece should rest along upper style line of sheet
metal radius and not below it: see step 22. NOTE:
Foam insulation may need to be trimmed out of the
holes.
69
Secure inner piece D4 (and P4 for passenger side
installation) to the sheet metal using the following
4 STEPS: Step 1 Position inner piece on fender,
aligning with existing factory holes in sheet metal.
70
Hole
Locations
Hole
Location
Upper Style
Line