Product Manual
| Night Hawk Single Row LED Light Bars | Night Hawk Single Row LED Light Bars
Page 17 Page 18
The mounting feet can be moved through 200° rotation by utilising the two individual
channels in the body of the light bar and the two hole positions in the mounting feet. All
congurations shown below:
Angle Adjustment
RECOMMENDED TORQUE SETTINGS
M6 Fasteners 8Nm
M8 Fasteners 22Nm
Wiring Options
The light bars can be wired into the vehicle using 2 methods:
1. VLI Wiring System (P/N: NHW20VLI, available separately)
Vehicle Mounting & Adjustment
Light bars can be mounted using the supplied mounting feet or tube clamps are available
(sold separately) for bar mounting applications. When using mounting feet, all mounting
feet supplied must be used, be tted symmetrically about the centre of the light and
positioned towards the ends of the light bar to reduce overhang.
Ensure the mounting location for tment of the light/s to the vehicle is at, stable, sufciently
strong and has enough clearance around the light to avoid damage to the vehicle from
any movement during installation and use. If drilling is required for mounting, ensure raw
edges are coated with corrosion resistant paint or inhibitor.
Apply anti-seize lubricant to the threads before nal installation. The use of anti-seize greatly
reduces the risk of thread galling or binding commonly seen between stainless steel nuts
and bolts during tightening. Tighten fasteners to the following torque specications: