Instruction Manual

Installing your induction hob
Bringing it all together
Installing your gas cooker
16
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
WARNING: This appliance must be installed by an authorised
service person or qualified technician, according to the
instructions in this guide and in compliance with the current
local regulations.
• Incorrect installation may cause harm and damage, for
which the manufacturer accepts no responsibility and the
warranty will not be valid.
• Prior to installation, ensure that the local distribution
conditions (electricity voltage and frequency and/or
nature of the gas and gas pressure) and the adjustments
of the appliance are compatible. The adjustment
conditions for this appliance are stated on the label.
The laws, ordinances, directives and standards in force in the
country of use are to be followed (safety regulations, proper
recycling in accordance with the regulations, etc.).
Instructions for the installer
General instructions
• After removing the packaging material from the appliance
and its accessories, ensure that the appliance is not
damaged. If you suspect any damage, do not use it
and contact an authorised service person or qualified
technician immediately.
• Make sure that there are no flammable or combustible
materials in the close vicinity, such as curtains, oil, cloth
etc. which may catch fire.
• The worktop and furniture surrounding the appliance
must be made of materials resistant to temperatures
above 100°C.
• If a cooker hood or cupboard is to be installed above the
appliance, the safety distance between cooktop and any
cupboard/cooker hood should be as shown below.
HOB
Minimum
42 cm
Minimum
42 cm
Minimum 65
cm (with hood)
Minimum 70
cm (without
hood)
• The appliance should not be installed directly above a
dishwasher, fridge, freezer, washing machine or clothes
dryer.
• If the base of the appliance is accessible by hand, a barrier
made from a suitable material must be fitted below the
base of the appliance, ensuring that there is no access to
the base of the appliance.
• If the hob is installed above an oven, the oven should
have a cooling fan.
• Make sure that the induction hob is well ventilated and
the air inlet and outlet are not blocked.
Installation of the hob
The appliance is supplied with an installation kit including
adhesive sealing material, fixing brackets and screws.
• Cut the aperture dimensions as indicated in the figure.
Locate the aperture on the worktop so that, after the hob
is installed, the following requirements are followed.
W (mm) 590 min. A (mm) 50
D (mm) 520 min. B (mm) 50
H (mm) 53 E (mm) 10
C1 (mm) 560 min. F (mm) 10
C2 (mm) 480 G (mm) 20