Instruction Manual
Using your DAB Alarm Clock Radio
Let’s get started
Using your DAB Alarm Clock Radio
Let’s get started
Using your DAB Alarm Clock Radio
Using your DAB Alarm Clock Radio>
28
29
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
4. Alarm 1 Setup is displayed (Press and release the Vol.+ button to set Alarm 2). Press
and release the Select button.
5. Alarm 1 Wizard On time is displayed and the hour digits for the alarm will flash.
6. Press and release the Prev or Next buttons to scroll to the hour for the alarm and press
and release the Select button.
7. The minutes will now flash. Press and release the Prev or Next buttons scroll to the
minutes for the alarm and press and release the Select button. The duration time will
now flash.
8. Press and release the Next button to scroll to the duration for the alarm. You can
choose from 15, 30, 45, 60, 90 and 120 minutes. Press and release the Select button.
The source for the alarm will now flash.
9. Press and release the Next button to scroll to the sound source for the alarm. You can
choose from Buzzer, DAB or FM. Press and release the Select button.
Note: If you select DAB or FM radio for the alarm source, ‘Last listened’ will flash in the
display. Press and release the Select button and the last listened to radio station in DAB
or FM, as appropriate, will be used for your alarm.
10. Press and release the Next button to scroll to the frequency for the alarm. You can
choose from Daily, Once, Weekends or Weekdays. Press and release the Select button.
Note: If you select ‘Once’, you will then be prompted to set the date for your alarm.
11. Press and release the Prev or Next buttons to set the volume for your alarm.Press and
release the Select button.
Note: Remember to set the alarm radio volume to one that will wake you. You will not
be able to set the volume for less than 5 bars for this reason. When the alarm sounds,
the volume will increase progressively until it reaches the alarm volume that you have
set.
12. Alarm 1 Wizard is displayed again, together with Alarm Off (or On). Press and release
the Next button to choose Alarm On or Off and press and release the Select button to
confirm. Alarm Saved is displayed.
13. An alarm clock symbol will appear in the radio display to confirm that an alarm has
been set.
Note: If the time is not set or has failed to update from the radio signal, Time is not set
will be displayed when you try to set the alarm. The radio will then prompt you to set
the time. An alarm can only be set after the time has been set.
Stop the Alarm
When the alarm sounds, press and release any button apart from the Snooze button,
Alarm off will be displayed. Alternatively, you can press and release the Snooze button (see
Snooze function below).
Note: When you press a button to stop the alarm, the alarm symbol will remain in the
display and the alarm will sound again at the same time the next day, unless it was set
for ‘Once’ only.
Snooze
When the alarm sounds you can press and release the Snooze button. Snooze will be
displayed, followed by the snooze time countdown from 9 minutes, until the alarm
sounds again.
Turn o the Alarm
Follow the steps for ‘Setting an Alarm’ and select ‘Off’ in step 12.
Sleep timer
You can set your radio to switch to Standby mode automatically using the sleep timer. You
can choose from Sleep off, 15, 30, 45, 60 and 90 minutes.