Installation and Operation Manual

SECTION 11 I - INSTALLATION INSTRUCTIONS
a INSTALL FLUE COVER PLATES over cleanout
openings 'on left side of boiler as shown in Figure 13.
CLEANOUT COVER 7 r COVER GASKET
A. Locate the cover plates, carriage bolts, nuts and wash-
ers in the miscellaneous parts carton.
B. Attach the carriage bolts to the top and bottom of the
flue openings with washers and hex nuts to provide a
INSULATION
fixed stud.
C. Install flue cover plates & gaskets over studs and secure
with washers and nuts.
CLEANOUT NU
AND WASHER
@ MOUNT PRESSURE RELIEF DOOR
TOP VIEW
A. Apply a %" bead of Silastic along the groove on the
CLEANOUT COVER ASSEMBLY
inside face of the pressure relief door.
Fig. 13
B. Mount the pressure relief door onto the rear section
(with the word "Top" in the upright position) using
the (4) -&"-18 x
1" cap screws located in the miscell-
aneous parts carton.
Install the refractory firewall plates on the right
side of the center sections. The plates should be 'installed
toward the front of the boiler.
See Figure 14.
IMPORTANT
- THIS BOILER REQUIRE'S NO COM-
BUSTION CHAMB.ER.
@ MOUNT BURNER MOUNTING PLATE
A. Cast iron burner mounting plate. Install (10)
15" x 2
long studs with the short length of threads into the
boiler front section. Apply a bead of sealant around
the periphery of the cast iron burner plate and secure
to front section with
h'' nuts and washers.
B. Cast iron burner mounting plate with adapter plate
(R-6 Burner Only). The adapter plate is furnished by
Gordon-Piatt and
'is shipped with the burner. Mount
the cast iron burner mounting plate as stated in (A)
above. Mount the adapter plate to the mounting plate
with
(8) %" x 1%" cap screws, %-I6 hex nuts, washers
and gasket provided. The R6 burner can now be secur-
ed to (4) studs on adapter plate using
(4) %-I6 hex
nuts and washers.
FIREWALL PLATES
Fig. 14