Installation and Operation Manual

PUMP AND

CHANNEL BLOCK

3''

--q

DRAW UP

-3

REQ'D

BLOCK

PUMP AND

HYDRAULIC DRAW-UP

SECTIONS

Fig.

ROD CLAMP

RAM

SET

HYDROSTATIC TEST

After the boiler sections

C. Testing pressure should be

least

pounds but

should not exceed

pounds.

have been assembled, it is essential that the boiler be hy-

drostatically tested before platework, jacket, or piping is

installed. D.

Tankless Heater Installation

If boiler is ordered with tankless heaters, install heat-

ers with the gaskets provided. Table

on page

gives the maximum number of heater permissible per

assemblage and the heater ratings.

Plug all boiler tappings and fill entirely

with

cold

water. To protect and safeguard the accuracy of steam

or water gauge supplied, DO NOT INSTALL GAUGE

UNTIL AFTER TESTING OF BOILER.

EXAMINE BOILER CAREFULLY, INSIDE AND

OUTSIDE, to insure against leaks from cocked nipples

or through concealed breakage caused in shipping and

handling. This precauti'on is for your protection and

will simplify handling of necessary replacements and

adjustment claims.

After making certain that there

are no leaks, drain

boiler and remove plugs for boiler trim and other con-

nections.