Coffee Brewer Installation & Operating Guide

Page 5

PLUMBING REQUIREMENTS

These brewers must be connected to a cold water system with operating pressure between 20 and 90 psi

(138 and 620 kPa) from a

⁄2" or larger supply line. A shut-off valve should be installed in the line before the

brewer. Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to 50 psi (345

kPa). The water inlet ﬁtting is

⁄4" ﬂare. Bunn-O-Matic does not recommend the use of a reverse-osmosis or

deionized water supply to this equipment.

NOTE - Bunn-O-Matic recommends

⁄4" copper tubing for installations of less than 25 feet and

⁄8" for more than

25 feet from the

⁄2" water supply line. A tight coil of tubing in the water line will facilitate moving the brewer to

clean the countertop. Bunn-O-Matic does not recommend the use of a saddle valve to install the brewer. The

size and shape of the hole made in the supply line by this type of device may restrict water ﬂow.

FIG 3

40410 022908

This equipment must be installed to comply with the International Plumbing Code of the International

Code Council and the Food Code Manual of the Food and Drug Adminis-tration (FDA). For models installed

outside the U.S.A., comply with the applicable Plumbing /SanitationCode.

Plumbing Hook-Up

1. Flush the water line.

2. Securely attach the Strainer/Flow Control and tube assembly to the water supply line.

3. Securely attach tube assembly to the ﬂare ﬁtting at the rear of the brewer.

4. Turn on the water supply.