INSTALLATION & OPERATING GUIDE BUNN-O-MATIC CORPORATION POST OFFICE BOX 3227 SPRINGFIELD, ILLINOIS 62708-3227 PHONE: (217) 529-6601 FAX: (217) 529-6644 To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and manual updates.
BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) Airpots, thermal carafes, decanters, GPR servers, iced tea/coffee dispensers, MCP/MCA pod brewers thermal servers and Thermofresh servers (mechanical and digital)- 1 year parts and 1 year labor. 2) All other equipment - 2 years parts and 1 year labor plus added warranties as specified below: a) Electronic circuit and/or control boards - parts and labor for 3 years.
INTRODUCTION 1 This equipment will brew a ⁄2 gallon batch of coffee into an awaiting server. The brewer may have a hot water faucet for allied beverage use. It is only for indoor use on a sturdy counter or shelf. CONTENTS Warranty................................................................................................ 2 User Notices ......................................................................................... 3 Electrical Requirements ....................................................
ELECTRICAL REQUIREMENTS WARNING The brewer must be disconnected from the power source until specified in Initial Set-Up. Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements. ELECTRICAL HOOK-UP (All Models) CAUTION – Improper electrical installation will damage electronic components. 1. An electrician must provide electrical service. 2. Determine the available on-site electrical service. 3.
ELECTRICAL REQUIREMENTS Single & Dual Volt Models Requirements for brewers with an attached cord set are as follows: Note: This electrical service requires 2 current carrying conductors (Neutral, and L1) and a separate conductor for earth ground. Dual Voltage Switch in 120V position 120V 120/208-240V For Supply Connections, Use No.
PLUMBING REQUIREMENTS These brewers must be connected to a cold water system with operating pressure between 20 and 90 psi (138 and 620 kPa) from a 1⁄2" or larger supply line. A shut-off valve should be installed in the line before the brewer. Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to 50 psi (345 kPa). The water inlet fitting is 1⁄4" flare.
OPERATING CONTROLS (A) ENABLE BREW ON/OFF SWITCH Pressing the "ENABLE BREW ON/OFF" switch (indicator on) supplies power to the brew station warmer and enables the brew circuit. Pressing the switch again (indicator off) stops brewing and de-energizes the brew station warmer. Stopping a brew cycle after it has been started will not stop the flow of water into the server until the funnel is empty.
CLEANING 1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment. 2. Check and clean the sprayhead. The sprayhead holes must always remain open. Insert the short end of the sprayhead cleaning tool into each of the five water outlets of the plastic sprayhead to remove any mineral deposits (Refer to Fig 1) 3.
ADJUSTMENTS & OPTIONAL SETTINGS 1 3 %811 2 READY TO BREW WATER TEMP: 200° 5($5 )5217 :$50(5 :$50(56 P3633-2 4 Using the menu-driven display on the front of the brewer, the operator has the ability to alter or modify various brewing parameters such as brew lockout, brew volume, brew strength, etc. This allows for the precise brewing of various flavors of coffee. Programming of the brewer is achieved by entering a certain function.
ADJUSTMENTS & OPTIONAL SETTINGS (CONT.) PROGRAMMING FUNCTIONS - FLOW CHART BrewWIZARD BREW OZ: 64.0 BREW LOCKOUT ? NO DONE YES ENABLE ADS ? NO DONE YES (-) DONE (+) BREW METER - + ENTER SERVICE #? NO 1 EXITING YES BrewWIZARD LEVEL 2 ENTER PASSWORD 0 0 0 UNITS METRIC DONE ENG SET PASSWORD 0 0 SET TEMP: (-) DONE 0 200° (+) SET LANGUAGE ? NO YES SET READY: (-) DONE 195° (+) (CONT.
ADJUSTMENTS & OPTIONAL SETTINGS (CONT.) LEVEL 2 (CONT.) ENTER ASSET # ? SET PULSE BREW ? NO NO YES ENABLE CLEAN NO DONE YES YES DRIP T I M E 0:30 (-) DONE (+) Enabl EnergySavr EnableFreshTimer NO NO DONE YES DONE YES (Ver. 1.07 & above) ENABL WARMER OFF NO DONE YES 0 (-) REFILL 155 DONE (+) ENABLE BrewLOGIC NO DONE YES (These two screens will change if "BrewLogic" is enabled) SPRAY OZ/M: (-) DONE 25.