Installation and Operating Guide

7
DISPENSER USE
Press and Hold Dispensing:
1. Place a container beneath the dispensing nozzle.
2. Press and hold either the “still” water switch or the “sparkling” water switch until the beverage reaches the desired
level, then release.
Portion Control Dispensing:
The portion sizes are preset but can be changed as follows:
1. Set the program switch to the ON position.
2. Press and hold the large and medium buttons on the left (STILL WATER) until you hear the machine “beeps” three
times.
3. Place a container beneath the dispensing nozzle then press and hold the appropriate dispense switch until the
desired amount has been dispensed. The machine will record the amount of time that the button is pressed continu-
ously. If the button is released too soon, simply empty the container and start over.
4. Repeat step 3 for each of the dispense switches as desired.
5. Turn the program switch to the OFF position.
CHANGE WATER FILTER CARTRIDGE WARNING
The water filter cartridge will need to be changed after 4,500 gallons of use. When the water usage gets close to 4,500
gallons, the blue LED will flash slowly to indicate that it is nearly time to replace the water filter cartridge. When the
water usage exceeds 4,500 gallons, the blue LED will flash rapidly to indicate that it is time to replace the water filter
cartridge. Once the water filter cartridge has been replaced, push and hold the water filter reset switch for 3 seconds to
clear the warning.
CHANGING THE WATER FILTER CARTRIDGE:
1. To change the water filter cartridge, shut off the water supply line and remove the water supply line at the dispenser.
2. Turn the water filter cartridge counterclockwise to remove it from its mounting bracket.
3. Install the new water filter cartridge into the mounting bracket by turning it clockwise until it is tight.
4. The new water filter cartridge should be flushed with at least five gallons of water before re-connecting the water
supply line at the dispenser.
CLEANING & PREVENTIVE MAINTENANCE
Daily:
1. Wipe splash panel, areas around dispense nozzle with a clean, damp cloth.
2. Wipe external surfaces with a clean, damp cloth.
Monthly: Clean Condenser Coils and Air Filter:
1. Removable air filter can be cleaned in warm soapy water.
2. Use a soft bristle brush to clean the build up of dirt in the condenser.
52373.0 103015