USER GUIDE Read Before Use! 113-FLR 120-FLR Do not use on High Pressure Laminate or Solid Wood www.BulletTools.com • 208-772-0175 PRT-INS-0100 RevC.02.
WARNING: FAILURE TO FOLLOW THIS GUIDE MAY RESULT IN SERIOUS INJURY! USING THIS MACHINE WITH RESPECT AND CAUTION WILL CONSIDERABLY REDUCE THE RISK OF PERSONAL INJURY. SAFETY GUIDE FOR THE EZ SHEAR™ FLR Series 1 �����READ AND UNDERSTAND THIS INSTRUCTION MANUAL BEFORE OPERATING THE EZ SHEAR™. 2 �����If you are not thoroughly familiar with the operation of the EZ Shear™, obtain advice from a qualified instructor or call 800-406-8998 (Intl.: 208-772-0175). 3 �����Stay alert.
Set up Welcome! Your EZ Shear FLR Comes ready to assemble.* *You will need #2 & #3 Phillips head screwdrivers and a 1/2” (13mm) socket or wrench. Please Review and Verify Parts Included in Box: 1. Power Assembly 1a. Safety Lock pin 2. Handle Assembly 3. Fence 4. Table 5. Tail 6. Rails (2) 7. Hone Stone 8. Hardware Kit 1a. 2. F. 1. E. D. 5. C. G. H. 3. A. 4. 7. Hardware kit: Item A. Item B. Item C. Item D. Item E. Item F. Item G. Item H. 6. B.
Set Up 3 3A 3. Attach Table 3B Item E A. Attach front of table to base, using Item D screws. Tighten with #3 Phillips. B. Attach back of table to tail using Item E self tapping screws. Tighten with #2 Phillips. Item D 4 4. To Attach Handle: Item F Insert Item F screws and tighten with 1/2” (13mm) wrench. Note: To ensure correct alignment, start each of the bolts by hand before using wrench. 5.
MAKING CUTS Caution! Wear hand and eye protection while operating the EZ Shear™ 1 Pull Safety Lock pin While gently pushing handle down, pull Safety Lock pin out, then lift handle. 2 Place product on table. Bring handle down until blade touches material. 3 Push the handle down until the material is completely cut. DO NOT USE ON HIGH PRESSURE LAMINATE OR SOLID WOOD! Warning! Blade is very sharp. Keep fingers away from blade. Most materials listed on page (6) shear cleanly with just one cut.
Your EZ Shear cuts a wide variety of products. Please refer to this cut guide for recommended products and thicknesses. FLR CUT GUIDE MAINTENANCE Honing the Blade Maximum Thickness = 15mm or 5/8” Material Laminate Flooring Engineered Wood Hone every 100 cuts Commercial Vinyl Luxury Vinyl Tile Parquet Permastone™ PVC Tile Rubber Cove Base Push the handle down until blade is 1/4” (6mm) open. Lay the hone stone against the flat face of the blade (side toward the table).
WARRANTY 30 Day Satisfaction Guarantee Bullet Tools™ is confident that you will be absolutely pleased with the purchase of our product. If, for any reason, you are not completely satisfied with your tool, we will refund your purchase price at any time within 30 days of your original purchase (receipt required). If you want to return your product under our 30-day no risk trial offer (valid only for purchases made in the US), please contact us at 1-800-406-8998 or 208-772-0175 for return instructions.
