User's Manual
Table Of Contents
- User Manual
- Chapter 1 - Product Overview
- Chapter 2 - Installation
- Chapter 3 - Configuration
- Installing the AirStation Configuration Tool (Windows)
- Setting the AirStation IP Address (Windows)
- Setting the AirStation IP Address (Mac OS X)
- Accessing the Web-based Configuration Interface (Windows)
- Accessing the Web-based Configuration Interface (Mac OS X)
- Configuration Interface Menus in Router Mode
- Configuration Interface Menus in Bridge Mode
- Setup
- Internet/LAN (LAN Config)
- Wireless Config
- Security (Router Mode only)
- LAN Config
- Admin Config
- Diagnostic
- Chapter 4 - Connect to a Wireless Network
- Chapter 5 - Troubleshooting
- Cannot connect to the Internet over wired connection.
- Cannot access the web-based configuration Interface.
- Cannot connect to the network wirelessly.
- You forgot the AirStation's SSID, Encryption Key, or Password.
- If the AirStation is reset, it is disconnected from the network.
- The link speed is slower than 300 Mbps.
- Other Tips
- Chapter 6 - Default Configuration Settings
- Chapter 7 - Checking Wireless Signal Quality
- Chapter 8 - TCP/IP Settings
- Chapter 9 - Restoring the Default Configuration
- Appendix A - Specifications
- Appendix B - Regulatory Compliance Information
- Appendix C - Environmental Information
- Appendix D - GPL Information
- Appendix E - Warranty Information
WPL-05G300 Series User Manual 62
Chapter 3 Conguration
Parameter Meaning
Reject IDENT Requests
Enabling this option will answer IDENT requests from the Internet
side with corresponding rejection packets. Enable this option if
you experienced slow transfer speeds for network applications
such as mail, ftp or web browsing. If you have congured transfer
of IDENT requests to the LAN side computer in the address
translation settings (DMZ or TCP port 113), then that setting has
higher priority, and overrides this setting.
Block Ping from Internet
If this is enabled, the AirStation will not respond to pings from the
Internet side. You can congure this with PPPoE if you select [Use
PPPoE Client] or [Use IP Unnumbered] in Method of Acquiring IP
address (page 36), or if Easy Setup identied a PPPoE connection
during setup.