User's Manual
Table Of Contents
- User Manual
- Chapter 1 - Product Overview
- Chapter 2 - Installation
- Chapter 3 - Configuration
- Installing the AirStation Configuration Tool (Windows)
- Setting the AirStation IP Address (Windows)
- Setting the AirStation IP Address (Mac OS X)
- Accessing the Web-based Configuration Interface (Windows)
- Accessing the Web-based Configuration Interface (Mac OS X)
- Configuration Interface Menus in Router Mode
- Configuration Interface Menus in Bridge Mode
- Setup
- Internet/LAN (LAN Config)
- Wireless Config
- Security (Router Mode only)
- LAN Config
- Admin Config
- Diagnostic
- Chapter 4 - Connect to a Wireless Network
- Chapter 5 - Troubleshooting
- Cannot connect to the Internet over wired connection.
- Cannot access the web-based configuration Interface.
- Cannot connect to the network wirelessly.
- You forgot the AirStation's SSID, Encryption Key, or Password.
- If the AirStation is reset, it is disconnected from the network.
- The link speed is slower than 300 Mbps.
- Other Tips
- Chapter 6 - Default Configuration Settings
- Chapter 7 - Checking Wireless Signal Quality
- Chapter 8 - TCP/IP Settings
- Chapter 9 - Restoring the Default Configuration
- Appendix A - Specifications
- Appendix B - Regulatory Compliance Information
- Appendix C - Environmental Information
- Appendix D - GPL Information
- Appendix E - Warranty Information
WPL-05G300 Series User Manual 10
Chapter 1 Product Overview
8
AOSS Button
To initiate AOSS, hold down this button until the Security LED ashes (about 1 second). Then,
push or click the AOSS button on your wireless client device to complete the connection. Both
devices must be powered on for this to work.
9
PLC Button
Hold down
for 1 to 3 seconds:
This starts the PLC connection process or cancels the connection process.
If the Power LED indicates that the PLC connection has failed, the Power
LED stops blinking.
Hold down
for 10 seconds:
This disconnects the PLC connection.
10
Reset Button
To reset all settings, hold down this button until the amber power LED ashes (about 3
seconds). Power must be on.
11
Wireless Button
This is not used in this product.
12
Router Switch
Switches router mode between enabled, disabled, and auto.
On: Router functionality is enabled (router mode).
O: Router functionality is disabled (bridge/AP mode).
Auto: This switches between modes automatically based on whether or not
another router is detected on the Internet port. The default setting for
this switch is Auto.