Installation Guide

Questions about installation? Call our customer service department at 888-542-3355 or visit brondell.com

BF200/BF400 Filtered Water Faucet Installation

Top Spout

Main Body

Top Cap

Large Rubber Washer

Small Rubber Washer

Lock Washer

Locking Nut

Escutcheon

Counter Top

Plastic Washer

(connected to faucet)

1/4” Tube

Installing the Faucet

1. Unpack the faucet and insert the Top Spout into the Main Body by

pushing down until fully inserted, then screw the Top Cap clockwise

until secured in place.

2. Cut zip tie on the blue water connection tubing and unroll to

straighten tubing. Be careful not to cut the tube when removing the

zip tie.

3. Install the Escutcheon (faucet base), curved lip side down, by

inserting the blue tubing through the Escutcheon and the Large

Rubber Washer and push both all the way up until adjacent to the

Main Body.

4. Install the faucet on top of the countertop or sink and feed the blue

tubing through the hole to the cabinet below. Slide the large Plastic

Washer and Small Rubber Washer as shown to the left up through the

blue tubing until snug against the bottom of the countertop or sink

hole.

5. Install the Lock Washer and the Locking Nut the same way and

tighten until the Plastic Washer and Small Rubber Washer are holding

the faucet assembly ﬁrmly in place. The faucet is now installed!

PAGE 1
BF200/BF400 Filtered Water Faucet Installation Installing the Faucet 1. Unpack the faucet and insert the Top Spout into the Main Body by pushing down until fully inserted, then screw the Top Cap clockwise until secured in place. 2. Cut zip tie on the blue water connection tubing and unroll to straighten tubing. Be careful not to cut the tube when removing the zip tie. Top Spout 3.
PAGE 2
BF100/BF300 Filtered Water Faucet Installation & Battery Replacement Installing the Faucet 1. Unpack the faucet and insert the Top Spout into the Main Body by pushing down until fully inserted, then screw the Top Cap clockwise until secured in place. 2. Cut zip tie on the blue water connection tubing and unroll to straighten tubing. Be careful not to cut the tube when removing the zip tie. 3.