Installation Guide

INSTALLATION MANUAL

INSTALLATION

HORIZONTAL EXHAUST INSTALLATION ONLY

VERTICAL EXHAUST INSTALLATION AND NON-DUCTED INSTALLATION ONLY

OTE: N The following procedure applies to both frame or frameless cabinet installations.

Install the Hood (EZ1 Bracket)

1 ] Run house power cable between service panel and hood location.

2 ] There are 2 pairs of recessed holes on each side of the top of the hood (on rear: A and B,

on front C and D on illustration below); these holes allow the range hood to hang on the

brackets (previously installed).

3 ] Temporarily hang the hood on the brackets using its (2) recessed REAR HOLES (A and B).

While holding the hood, run the house power cable into the hood through the strain relief

previously installed in step 6 on page 10.

4 ] Unhook the rear holes from the brackets and hang the hood using its (2) recessed FRONT

HOLES (C and D). Attach power cable to the hood using the strain relief.

5 ] Hang the hood on the brackets using the (2) recessed FRONT HOLES (C and D). While

holding the hood, run the house power cable into the hood through the strain relief previously

installed in step 6 on page 10. Secure power cable to the hood using the strain relief.

6 ] Connect ductwork to hood and use metal foil duct tape to make joints secure and air-tight.

Make sure the damper assembly (or round duct plate) enters the ductwork and that the

damper opens and closes freely.

NOTE: See final installation steps on next page.

DUCTED INSTALLATION ONLY