User guide

ManualsBrandsBrewer ManualsFurnitureElement Treatment 2010

Overview

.............................................................. 2

Hardware............................................................... 2

Assembly............................................................ 3-4

Maintenance ...................................................... 6

Accessories ...................................................... 6

Limited Warranty ............................................... 6

Installation..........................................................5

Tools Needed......................................................... 2

Model 2010

Summary of content (7 pages)

PAGE 1
Model 2010 Overview .............................................................. 2 Tools Needed......................................................... 2 Hardware............................................................... 2 Assembly............................................................ 3-4 Document 101289 RevA 1 Installation.......................................................... 5 Maintenance ...................................................... 6 Accessories ...........................
PAGE 2
OVERVIEW COMPONENT IDENTIFICATION NOTE: Save all packaging in case re-shipment is required. Perform the following sequence in order when setting up the table: Unpacking Assembly Leveling the Table Installing the Paper Roll NOTE: Inspect all boxes and contents for damage. Report any damage to the carrier immediately. MODEL 2010 For the above models you will receive two separate cartons: a frame carton, and an upholstery carton. Inspect both carefully for shipping incurred damage.
PAGE 3
MODEL 2010 STEP 1 Notch Screw C Screw C STEP A: Start with table frame inverted: note the position of the Notch in the drawing above is facing upwards. STEP B: Positon legs (see drawing above). Insert Screws C (1/4”-20 x 1 1/4”) by hand. Tighten screws using Allen Wrench provided.
PAGE 4
MODEL 2010 STEP 2 J-Bolt R Nut L Washer M STEP A: Install J-Bolts as shown in Figure A. Thread Nut L (3/8”) completely onto J-Bolt. Place Washer M onto J-Bolt and thread into Backrest as shown in Figure A. Position J-Bolt toward head of table as shown and tighten nut against backrest.
PAGE 5
INSTALLATION Leveling the Table A Leveling Screw Pad is located at each corner under the table’s base. Adjust the four Leveling Screw Pads, by turning them up or down, to achieve a solid, level installation.
PAGE 6
MAINTENANCE Preventative Maintenance • Inspect the mechanical functions to ensure satisfactory operation. • Check fasteners to make sure they are present and secured tightly. Painted Metal Surfaces Wipe all painted metal surfaces with a clean cloth at least once a week. ACCESSORIES Cleaning Upholstery Regular care should be maintained by daily wiping with a damp cloth or sponge and periodic cleaning with a mild soap and water solution. Let air dry before placing anything on top of upholstery.