Use and Care Manual

5
Using Your Stand Mixer:
WARNING: Avoid contact with moving parts.
1. Place the Stand Base on a clean and sturdy flat surface. The Non Slip
feet will keep the appliance in place.
2. Press the Head Tilt Button on the side of the Stand Base to tilt the head
back. Insert the Stainless Steel Bowl in place and return the Mixer Holder
to its place.
3. Add the ingredients you would like to mix to the Stainless Steel Bowl.
4. Before connecting the appliance, insert the beaters that best
accommodate the mixing you will be doing to the Hand Mixer.
5. Once they are locked in place insert the mixer on the Mixer Holder.
6. Make sure the grooves of the Mixer Holder lock with the grooves of the
Mixer.
7. Connect Plug to the nearest 120 V AC electrical outlet.
CAUTION: Do not touch Moving parts with fingers or objects.
8. Mix using a slower speed at first, gradually building. Turbo button can be
used once dry ingredients have been incorporated with wet ingredients
as to avoid splatters.
Attention: First use may cause a slight odor or small smoking upon
heating, it is normal. This is a result of the heating element chemical
reaction. It quickly goes away.
9. Mix ingredients to the desired consistency and turn the dial back to “0”
to turn off, disconnect from the power supply to clean.
10. You can eject the beaters by pressing down firmly on the Speed Control
Dial.
11. You can remove the bowl and use a rubber spatula to scrape batters or
ingredients as it will not damage or scratch the Stainless Steel Bowl.
Cleaning Your Stand Mixer:
WARNING: Always unplug the product before cleaning or storing it.
NOTICE: Never immerse the motor base, plug or cord in water or any other
liquid.
 It is recommended to rinse parts immediately after use to make
cleaning easier.
 Before handling Beaters make sure the appliance has been
disconnected.