Owner manual
10
• Turn the appliance on by pressing the on/off switch (4) and cut hair to the
desired length.
Hair cutting without hair clipping comb
• Remove the clipping comb.
• To start clipping, turn the appliance on by pressing the on/off switch (4).
• Move the cutting system only in a parallel position to the skin (A, cutting
hair). Slowly and carefully move the appliance against the direction of hair
growth.
• Only when trimming contours the cutting system should be positioned
vertically (B, trimming).
• Make sure you do not tilt the appliance while it is touching the skin (C).
• Avoid jerky movements while cutting.
Cleaning
The appliance is suitable for cleaning under running tap water.
Warning: Detach the appliance from the power supply before
cleaning it with water.
Regular cleaning ensures better trimming performance.
Cleaning with the brush
• Switch off the appliance. Open the cutting system by pressing with the
thumb against the trimmer from the front side. It opens by ca. 45°.
• Using the brush clean the trimmers and the space behind the trimmer
(inside the housing).
Cleaning with water
• Switch off the appliance and rinse the head and the trimmer under warm
running water. You can also rinse the opened cutting system.
Keeping your appliance in top shape
To keep the cutting system working properly, oil it with light machine oil (D)
after each use, especially when cleaning under running water.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries,
the appliance has to be fully discharged (by operating) every 6 months
approximately. Then recharge the appliance to full capacity.
92390681_HC5050_MN_S4-58.indd 1092390681_HC5050_MN_S4-58.indd 10 04.09.12 11:0404.09.12 11:04