Installation manual

Installation SS-3N/IR/STD, SS-3N/IR/WH
Bradley Corporation • 215-1493 Rev. G; ECM 11-08-011 10/24/11 15
Fill Soap Dispenser
The soap valve will dispense vegetable/coconut oil liquid soaps, synthetic detergents, viscous lotion soaps, and antiseptic solutions.
A 10-15% con cen tra tion is rec om mend ed for veg e ta ble or co co nut oil liquid soaps. Before filling, rinse out each soap tank with
hot water to remove packing dust. Shake water out thor ough ly and allow to dry. DO NOT OVERFILL!
Filler
Hole
#10 Screw
Leaf Spring will engage when
soap tank is pushed into place.
S65-291 (Gray)
includes:
S65-291A (Putty)
includes:
S65-291B (Coal)
includes:
Gray Tank w/Valve
(S11-220)
Putty Tank w/Valve
(S11-220A)
Coal Tank w/Valve
(S11-220B)
Leaf Spring
(S39-350)
Leaf Spring
(S39-350)
Leaf Spring
(S39-350)
Screw
(160-385)
Screw
(160-385)
Screw
(160-385)
Soap Tank Kits
Soap Valve Repair Kit (S65-258)
(includes Nut, Spring, Washer and Plunger)
Soap Blank
Gray (133-143)
Putty (133-143A)
Coal (133-143B)
Clean Soap Dispenser
Do not use abrasive cleansers to clean the soap tank. Abrasive cleaners can damage the surface.
Regular cleaning of the soap dispenser is recommended to ensure optimum performance and maximum service life. Cleaning the
soap dispenser monthly to remove soap residue, dirt, and other accumulations should become a regular part of your washroom
cleaning routine and general maintenance program.
Clean exterior: Use warm water and soap to clean the exterior of the soap dispenser. Dry with a soft cloth.
Clean interior: Inspect the interior of the tank for residue or coagulation of soap. If necessary, clean the tank according to the
following procedure:
1. Pour out any remaining soap in the tank.
2. Full the tank half-full of hot water and shake the tank to dislodge the soap residue.
3. Empty the water from the container and repeat steps 1 and 2 until the soap container is clean.
If rinsing alone does not remove the soap residue, place a small chain (24 inches long) into the tank with hot water and
shake the container until the chain dislodges the residue. Then remove the chain and rinse out the tank.
Clean internal components: Pump hot water through the soap dispenser until a clean flow of water comes out of the valve.
To change soap, pour out all of the soap from the dispenser ans rinse with hot water several times until all residue is
removed. Pump the valve until clean water appears. Rinse the dispenser with ethyl alcohol; air dry before refilling.