Installation Sheet

24
Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400 Installation
3/21/2018 Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007
10a
Door Hardware for Inswing Doors - Surface
Local codes vary from state to state. Check your local
codes before installing the coat hook and door pulls.
3"
(76mm)
3"
(76mm)
Flat Strike/Keeper
Using the flat strike/keeper as
a template, drill (2) Ø1/8" pilot
holes through one face of the
pilaster only. Secure the flat
strike/keeper with the #10 x 3/4"
flat head screws provided.
F
5-1/2"
(140mm)
With the door in the closed
position, place flat strike/
keeper so the latch slide bar
fits within the top notch.
E
30-3/4" (781mm)
(Bottom of Door)
42-3/4" (1086mm)
A.F.F
Position latch centered top to bottom and with the leading edge 3/8" (10mm) from the door edge.
Using the latch as a template, mark the hole locations and drill Ø1/4" holes through the door.
Secure latch to door with the #10-24 x 3/4" barrel nuts and #10-24 x 3/4" shoulder screws provided.
A
With the door in the closed position, position the strike/keeper on the pilaster and align the top so it
is 1/2" (13mm) above the bottom of the latch slide bar. Using the strike/keeper as a template, mark
the hole locations and drill Ø1/4" holes through the pilaster. Secure the strike/keeper to the pilaster
with the #10-24 x 3/4" barrel nuts and #10-24 x 1" shoulder screws provided.
B
3/8"
(10mm)
1/2"
(13mm)
For 34" - 36" doors, mark the location for the top hole on the inside face of the door 30-3/4" (781mm) up from the bottom of 58" tall
doors (42-3/4" (1086mm) above finished floor) and 5-1/2" (140mm) from the door edge. Drill (2) Ø1/4" holes (spaced 3-1/2" (89mm)
apart) through the door and secure the door pulls to the door with the #10-24 x 2" flat machine screws provided.
C
Place the coat hook 3"
(76mm) down from the top
and 3" (76mm) from the latch
side of the door (hook goes
on the inside face of the
door). Using the coat hook
as a template, drill (2) Ø9/64"
pilot holes through inside face
of the door only. Secure the
coat hook with the #10 x 5/8"
screws provided.
D
C
L