Installation Sheet

3
Installation Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007 3/21/2018
WARNING
Before beginning installation, make sure that the wall and floor backing are adequate to support the secure
mounting of the toilet compartment units.
NOTICE
To prevent warping, always lay the material flat. Do not lean the material against the wall or stack unevenly.
To prevent "dimpling," extra caution should be taken when instructed to drill through one side of face only.
IMPORTANT
Read this installation manual completely to ensure proper installation, then file it with the owner or
maintenance department. This installation manual provides instruction for the assembly of normal partition
configurations and standard components. Non-standard configurations or components including but not
limited to curved or angled walls, partial walls, oversized panels, or modified hardware are not covered in
this manual. Compliance and conformity to local codes and ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before discarding packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
Product warranties and parts information may be found on Bradley's web site at bradleycorp.com.