Installation Sheet

27
Installation Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007 3/21/2018
11
Urinal Screens with Stirrup Brackets (Standard)
Before installing the urinal screen components,
determine the correct location for your application.
Draw a plumb line on the wall to represent the urinal screen
centerline. Measure from the highest point in the room and
place a mark on the urinal screen centerline at dimensions
"A" and "B" for the respective urinal screen height (see table
below).
A
Position and center brackets at each mark and urinal screen
centerline. Using the bracket as a template, mark the hole
locations on the wall. Remove the bracket and drill a Ø5/16"
hole (minimum 2" [51mm] deep) at each hole location.
B
Place the urinal screen at dimension "C" for the respective
urinal screen height (see table on right) and insert it into the
wall brackets until a 1" (25mm) gap between the wall and
urinal screen is established.
D
Insert plastic anchors in all holes and secure bracket to the
wall with the #14 x 2" screws provided.
C
Using the bracket as a template, drill Ø3/16" holes through
the urinal screen at each bracket hole. Secure the urinal
screen to the brackets with the #14 x 5/8" screws provided.
E
"A"
"B"
urinal
plumb line
floor
Dim "A" Dim "B" Dim "C"
42" Urinal Screen 24" (610mm) 54" (1372mm) 18" (457mm)
48" Urinal Screen 18" (457mm) 54" (1372mm) 12" (305mm)
"C"