Installation Sheet

9
Installation Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007 3/21/2018
5
Pilaster Mounting Hardware
This view is an example only. Refer to your submittal drawings to determine placement of the anchors on the pilaster
centerline for your application. Typical anchor centers are measured 1" (25mm) in from each edge of the pilaster (except 3"
pilasters where only one anchor is used).
A
Insert plastic anchors into the holes and
fasten the "L" brackets to the anchors
using the #14 x 2" screws provided.
C
Drill Ø5/16" holes (min 2" [51mm] deep) in
the floor and make sure the holes are free
of dirt and debris.
B
38"
(965mm)
Pilaster Centerline
22"
(559mm)
3"
(76mm)
6"
(152mm)
28"
(711mm)
4b
Alcove Brackets to Pilaster
Layouts that use continuous aluminum brackets for pilaster and panel connections will use stirrup brackets for alcove connections.
Continuous stainless steel brackets use continuous alcove brackets.
Refer to the submittal drawing for the layout location of each alcove pilaster.
Measure down from the top of
the pilaster and place a mark at
dimensions shown for the respective
bracket situation.
A
Stirrup: Position the center of each
bracket at the marks made in Step A.
Continuous: Center the bracket
between each mark made in Step A.
B
Using the bracket as a template,
mark the hole locations on the
pilaster. Remove the bracket and drill
Ø3/16" holes through the pilaster at
each location.
C
Secure the bracket(s) to the
pilaster using the #14 x 5/8" screws
(stainless on continuous) provided.
D
63-7/16"
(1611mm)
17-7/16"
(443mm)
Stirrup
Continuous
68-15/16"
(1749mm)
11-15/16"
(302mm)