Installation Sheet

23
Installation Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007 3/21/2018
10
Door Hardware for Inswing Doors - Concealed
Local codes vary from state to state. Check your local
codes before installing the coat hook and door pulls.
3"
(76mm)
3"
(76mm)
Flat Strike/Keeper
Using the flat strike/keeper as
a template drill (2) Ø1/8" pilot
holes through one face of the
pilaster only. Secure the flat
strike/keeper with the #10 x 3/4"
flat head screws provided.
F
4"
(102mm)
With the door in the closed
position, place flat strike/
keeper so the slot is centered
around the latch bolt.
E
30-3/4" (781mm)
(Bottom of Door)
42-3/4" (1086mm)
A.F.F
Assemble the latch as shown. Tighten the fasteners and insert
the latch bolt, pushing in until it snaps into place.
A
Place the strike/keeper on the pilaster and center it on the opposing latch
bolt. Using the strike/keeper as a template, mark the hole locations on the
pilaster. Remove the strike/keeper and drill an Ø1/4" hole through the pilaster.
Secure to the pilaster with the #10-24 x 3/4" barrel nut and
#10-24 x 1" shoulder screw provided.
B
For 34" - 36" doors, mark the location for the top hole on the inside face of the door 30-3/4" (781mm) up from the bottom of 58" tall
doors (42-3/4" (1086mm) above finished floor) and 4" (102mm) from the door edge. Drill (2) Ø1/4" holes (spaced 3-1/2" (89mm)
apart) through the door and secure the door pulls to the door with the #10-24 x 2" flat machine screws provided.
C
Place the coat hook 3"
(76mm) down from the top
and 3" (76mm) from the latch
side of the door (hook goes
on the inside face of the
door). Using the coat hook
as a template, drill (2) Ø9/64"
pilot holes through inside face
of the door only. Secure the
coat hook with the #10 x 5/8"
screws provided.
D