Installation Sheet

21
Installation Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007 3/21/2018
9a
Continuous Spring-Loaded Piano Hinge (Optional)
Place a door on a 12" (305mm) spacer and set the door gaps.
Standard hinge side gap is 9/32" (7mm).
A
Position the hinge so it is plumb and centered within the 9/32"
(7mm) gap and centered top to bottom (approximately 1/4"
(6mm) down from the top of the door).
B
Right-hand
inswing
(RHI)
Left-hand
inswing
(LHI)
Right-hand
outswing
(RHO)
Left-hand
outswing
(LHO)
Closed Door
View
Continuous Piano Hinge
Part # Prefix HDWT-S0209 Part # Prefix HDWT-S0208
The part numbers listed are prefixes only and
are used to identify the appropriate door kit
based on your door swing as determined above.
Inswinging doors should have hinges mounted
on the inside of the stall while outswinging doors
should have hinges mounted on the outside of
the stall.
(left hand in, right hand out,
knuckles facing front)
(right hand in, left hand out,
knuckles facing front)
Door
side
Pilaster
side
Door
side
Pilaster
side
Using the hinge as a template, drill Ø1/4" holes through the
door at the top and bottom holes. Secure the hinge to the door
using the #10-24 x 3/4" stainless barrel nuts and #10-24 x 3/4"
stainless shoulder screws provided.
C
Check to make sure the hinge side gap is still at 9/32" (7mm).
Using the hinge as a template drill Ø1/4" holes through the
pilaster at the top and bottom holes. Secure the hinge to the
pilaster using the #10-24 x 3/4" stainless barrel nuts and
#10-24 x 1" stainless shoulder screws provided.
D
Before installing the hinges, make sure the door openings are the appropriate size, all pilasters are plumb,
secured to the floor and that the headrail is installed.
Refer to your submittal drawings to determine each specific door swing for your application. The door swing is
determined by facing the compartment from the outside. The image below can help determine the door swing type.
Drill Ø1/4" holes through the remaining hinge holes on the door
and pilaster. Secure with the fasteners provided.
E
Spacer 12" (305mm)