Installation Sheet

5
Installation Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007 3/21/2018
*
*
*
*
*
*
C
L
C
L
C
L
C
L
C
L
C
L
Pilaster plumb line
When installing the partition components, consult
the applicable Mills Partition submittal drawing
for compartment layout dimensions.
1
Layout Dimensions - Stirrup Brackets (Standard)
Pilaster centerline: Measure from
the back wall forward to the face of the
compartment, subtract 5/8" (16mm) and
mark this location on the floor (“A”). Mark
the same measurement on the opposite end
of your layout (“A1”) and draw a straight line
connecting both marks.
For freestanding (FS) partitions: Refer
to submittal drawings and determine the
approximate location of the outside panels.
Establish dimensions “A” and “A1” as
explained above.
A
Panel centerline: Measure the stall width across the
back wall and place a mark at the base of the rear wall
(“B”). Repeat this step for each panel, starting each
measurement from the last panel centerline (“B1”).
B
Draw a plumb line on all walls from each pilaster
and panel centerline. From the highest point in the
room, measure 18" (457mm) and 64" (1626mm)
from the floor and place a mark on the pilaster/
panel plumb line. These marks represent the hole
center line of the stirrup brackets. Use a level to
transfer that mark to all other plumb lines (“C”).
C
Panel
plumb line
C
L
C
L
C
L
C
L
*
*
*
Pilaster plumb line
When installing the partition components,
consult the applicable Mills Partition submittal
drawing for compartment layout dimensions.
1a
Layout Dimensions - Continuous Brackets (Optional)
Pilaster centerline: Measure from
the back wall forward to the face of the
compartment, subtract 5/8" (16mm)
and mark this location on the floor (“A”).
Mark the same measurement on the
opposite end of your layout (“A1”) and
draw a straight line connecting both
marks.
For freestanding (FS) partitions:
Refer to submittal drawings and
determine the approximate location
of the outside panels. Establish
dimensions “A” and “A1” as explained
above.
A
Panel centerline: Measure the stall width across the
back wall and place a mark at the base of the rear wall
(“B”). Repeat this step for each panel, starting each
measurement from the last panel centerline (“B1”).
B
Draw a plumb line on all walls from each pilaster and panel
centerline. From the highest point in the room, measure from
the floor and place a mark on the pilaster/panel plumb line at
dimension "C" for the respective bracket type (see table below).
Use a level to transfer that mark to all other plumb lines "D".
C
Panel
plumb line
64"
(1626mm)
18"
(457mm)
"C"
"D"
"C"
"D"
"C"
"D"
"C"
"C"
"B"
"B"
"B1"
"B1"
"A1"
"A1"
"A"
"A"
"C"
"C"
Dim "C"
Stainless
Steel
12-1/2"
(318mm)
Aluminum
12-1/4"
(311mm)