Installation Sheet

29
Installation Powder Coated & Stainless Steel Restroom Partitions, Floor-Mounted with Overhead Brace — Series 400
Bradley • HDWT-INSTR-009 Rev K; ECN 17-14-007 3/21/2018
Before installing the urinal screen components, determine the correct location for your application.
Draw a plumb line on the wall to represent the urinal screen
centerline. Measure from the highest point in the room and place
a mark on the urinal screen centerline at dimension "A" for the
respective urinal screen height (see table below).
A
Insert plastic anchors in all holes and secure bracket to the wall
with the #14 x 2" stainless screws provided.
C
Place the bottom of the bracket on the mark and center the
opening on the urinal screen centerline. Using the bracket as
a template, mark the hole locations on the wall. Remove the
bracket and drill a Ø5/16" hole (minimum 2" [51mm] deep) at
each hole location.
B
11b
Urinal Screens with Continuous Aluminum Brackets (Optional)
Using the bracket as a template, drill Ø1/4" holes through the
urinal screen at each bracket hole. Secure the urinal screen to
the bracket with the #10-24 x 3/4" stainless barrel nuts and
#10-24 x 3/4" stainless shoulder screws provided.
E
Place the urinal screen at dimension "B" for the respective
urinal screen height (see table on right) and insert it into the
wall bracket until a 1" (25mm) gap between the wall and urinal
screen is established.
D
"A"
floor
"B"
Urinal Plumb Line
Brackets are used as templates, but since the hole patterns may be different, the brackets
may not be interchangeable.
Dim "A" Dim "B"
42" Urinal Screen 18-1/4" (464mm) 18" (457mm)
48" Urinal Screen 15-1/4" (387mm) 12" (305mm)