Installation / Operation Instruction Manual

6
Installation (Locating the Water Heater) continued-
NOTE: Damage to the water heater caused by exposure to corrosive vapors is
not covered by the warranty. Do NOT operate the water heater if exposure has
or will occur. Do NOT store any potentially corrosive compounds in the vicinity
of the water heater.
To comply with NSF requirements this water heater is to be:
a) Sealed to the floor with sealant, in a smooth and easily cleanable way,
or,
b) Installed with an optional leg kit that includes legs and/or extensions
that provide a minimum clearance of 6” beneath the water heater.
The water heater must be located close enough to the outside wall to keep the
venting distance within the maximum distance described in the installation
instructions. Locate the water heater as close as possible to the vent opening.