Spec Sheet
Residential Power Direct Vent
Energy Saver Gas Water Heater
The PDX2 FVIR Defender Safety System
®
Models Feature:
■ Bradford White ICON System
™
—Intelligent gas control with spark to pilot
ignition system eliminates the constant burning pilot. This results in savings of
pilot gas during stand by periods (120 V.A.C.).
-- Enhanced Performance—Proprietary algorithms provide enhanced First Hour
Delivery ratings and tighter temperature differentials.
-- Advanced Temperature Control System—Microprocessor constantly
monitors and controls burner operation to maintain consistent and accurate
water temperature levels.
-- Intelligent Diagnostics—An exclusive green LED light prompts the installer
during start-up and provides ten different diagnostic codes to assist in
troubleshooting.
-- Separate Immersed Thermowell—High strength advanced polymer
composite thermowell provides isolation between electric temperature sensor
and surrounding water. No need to drain the tank when removing gas valve.
■ Compatible With Optional Accessory Packages—Performance Package,
Protection Package and Inlet Shut-Off Valve.
■ Closed Combustion Venting System—Power Direct Vent closed combustion
system utilizes external air for combustion and exhausts directly to the outside
through a separate two-pipe system. The air intake and exhaust vent are 3"
connections. The equivalent feet of intake venting cannot be greater than the
equivalent feet of exhaust venting.
■ Cast Aluminum Air Intake Boot—A cast molded air intake boot design provides
exceptional durability during installation and operation.
■ Horizontal and Vertical Venting—With 3" or 4" PVC, ABS, or CPVC (Maximum
equivalent vent length for each pipe on reverse side).
■ Optional Concentric Vent Kit Termination—3" termination fitting provides for
only one exit opening through a wall or roof. (Subtract 10ft. for intake pipe and
10ft. for exhaust pipe when calculating total vent length.)
■ Flammable Vapor Sensor—Electronic sensor prevents burner operation if
flammable vapors are detected. The sensor will also prevent operation if there is
ongoing flammable vapor burn inside the combustion chamber.
■ Factory Installed Hydrojet
®
Total Performance System—Cold water inlet
sediment reducing device helps prevent sediment build up in tank. Increases first
hour delivery of hot water while minimizing temperature build up in tank.
■ Vitraglas
®
Lining—Bradford White tanks are lined with an exclusively engineered
enamel formula that provides superior tank protection from the highly corrosive
effects of hot water. This formula (Vitraglas
®
) is fused to the steel surface by firing
at a temperature of over 1600°F (871ºC).
■ 2" Non-CFC Foam Insulation—Surrounds the tank surface, saving energy by
retarding loss of heat.
■ Water Connections— 3⁄4" NPT factory installed true dielectric fittings.
■ 3/4" NPT Side Connections.
■ Factory Installed Heat Traps—Design incorporates a flexible disk that reduces
heat loss in piping and eliminates the potential for noise generation.
■ Protective Magnesium Anode Rod.
■ T&P Relief Valve—Included.
■ Low Restriction Brass Drain Valve—Durable tamper proof design.
6 or 10-Year Limited Tank Warranties / 6 or 10-Year Limited Warranty on Component Parts
For more information on warranty, please visit www.bradfordwhite.com
For products installed in USA, Canada and Puerto Rico. Some states do not allow limitations on warranties. See complete
copy of the warranty included with the heater.
Photo is of
PDX2-65T6FBN
MANUFACTURED UNDER ONE OR MORE OF THE FOLLOWING U.S. PATENTS: 5,954,492; 5,761,379; 5,943,984; 5,081,696; 5,988,117; 6,142,216; 5,199,385; 5,574,822; 5,372,185; 5,485,879; 5,277,171;
(B1)5,341,770; 5,660,165; 5,596,952; 5,682,666; 4,904,428; 5,023,031; 5,000,893; 4,669,448; 4,829,983; 4,808,356; 5,115,767; 5,092,519; 5,052,346; 4,416,222; 4,628,184; 4,861,968; 4,672,919; Re. 34,534;
7,270,087 B2. OTHER U.S. AND FOREIGN PATENT APPLICATIONS PENDING. CURRENT CANADIAN PATENTS: 1,272,914; 1,280,043; 1,289,832; 2,045,862; 2,112,515; 2,108,186; 2,107,012; 2,092,105; 2,409,271.
Defender Safety System
®
, Vitraglas
®
and Hydrojet
®
are registered trademarks of Bradford White
®
Corporation.
102-B-0713-A
FEATURING: