Use and Care Manual

KSAFE-SERIES SAFE DEPOSIT BOX INSTRUCTION GUIDE

Tip: please do not leave the emergency key. The external battery box is in your safe !

COMPONENT DESCRIPTION

PARTS LIST

Actual model may vary

OPENING YOUR SAFE FOR THE FIRST TIME

Note:

Please use the emergency key to open the safe for the first time. The operation is as follows.

1. Pick up the badge and

expose the emergency

keyhole passage.

4.Install the battery and open

the battery case

2. Insert the emergency key

into the keyhole and push it

to rotate 65°

counterclockwise.

5.Make sure the battery

matches the + and - in the car.

NOTES: Replace the batteries if the low

battery light is on.

3.Turn the handle clockwise

and the safe door opens.

6.Weak current no power, emergency start 2 methods:

1. Emergency key,

2 .external power box (install 4 AA batteries and plug them into the

external power hole, and operate normally after energizing)

PERSONAL PASSWORD SETTING

Note: This product factory has 2 sets of passwords, a set of personal passwords, one word management password.

1. In the state of opening the door, press the key of setting inside the door, the buzzer

will sound, and the backlight and "error" light will be on at the same time.

2. Enter the 1-8-bit password. After entering the password for the first time, press the "#" key and sound "Di" (if the

password is empty, this operation is invalid).

3. At this point, enter the same password, press the "#" key to confirm, and make a long "drop". At the same time,

"RIGHT" stops flashing and the system exits.

4. If the password entered in the first time is not the same as that in the second time, an error message will be

sounded like "Tick". After 1 second, re-enter the password.

PAGE 1
KSAFE-SERIES SAFE DEPOSIT BOX INSTRUCTION GUIDE Tip: please do not leave the emergency key. The external battery box is in your safe ! PARTS LIST COMPONENT DESCRIPTION Actual model may vary OPENING YOUR SAFE FOR THE FIRST TIME Note: Please use the emergency key to open the safe for the first time. The operation is as follows. 1. Pick up the badge and 4.Install the battery and open expose the emergency the battery case keyhole passage. 2. Insert the emergency key 5.
PAGE 2
ADMINISTRATIVE PASSWORD SETTINGS 1. In the state of opening the door, enter the password "00" in the digital key area, and press the "setting key" and the prompt of "di". At the same time, the backlight and the "ERROR" light are lit. 2. Enter the 1-8-bit password. After entering the password for the first time, press the "#" key (if the password is empty, this operation will be invalid), and "RIGHT" will flash. 3.