Use and Care Manual

147
13. Cut the indicated Zip-Tie without damaging the cables.
14.TiealengthofcableorwiretotheendoftheWirelessHeartRate
Sensor Cable at the top of the Console Mast. This cable or wire will be
used to route the new Cable through the Console Mast.
15. Gently pull the cable or wire into the Console Mast by pulling down-
ward the old Wireless Heart Rate Sensor.
16. Remove the old Wireless Heart Rate Sensor from the cable, and
dispose of it accordingly.
17. Tie the Cable to the Connector of the new Wireless Heart Rate Sen-
sor.
18. Gently pull the Cable through the Console Mast until the Connector is
at the top of the Console Mast.
NOTICE: Do not crimp the cables.
19. Re-assemble the machine in the reverse order of when the parts were
removed.
NOTICE: Do not crimp the cables.
20. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
Wireless Heart Rate
Sensor
Zip-Tie