Use and Care Manual

132
3. Gently lift and remove the Console/Static Handlebar Assembly from the
ConsoleMastanddisconnectthevecables(theInput/Output,LiftMotor,
ResistanceControl,WirelessHeartRate,andInclineControlCables)that
come from the back of the Console.
Note: Do not let the Cables fall down inside the Console Mast. If neces-
sary, use a rubber band or wire tie to secure them. This step may require
two people.
4.Usinga#2Phillipsscrewdriver,removethefourindicatedscrewsfrom
the Console and remove the Static Handlebar.
Note: Be sure to observe how the cables route through the Static Handle-
bar from the Console before removing it to assist with re-assembly. Do not
crimp the cables.
5. Re-assemble the machine in the reverse order of when the parts were
removed.
NOTICE: Do not crimp the cables.
6. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.