Technical data

TSplus Assembly Conveyors
8981 500 278 7/09
Bosch Rexroth Corporation
6
1. Pallet lift plate
2. Rotate unit position adjusting screws
3. Lift Unit Raised proximity switch
4. Line mounting plate
5. Parallel shaft indexer
6. Lift unit guide shafts
7. Lift Unit Lowered proximity switch
8. DC planetary gearmotor
9. Pneumatic lift cylinder
10. Rotation cycle cam
11. Rotate Cycle limit switch
12. Rotate Complete proximity switch
The individual components of the lift-rotate unit are as follows (Fig. 1):
Maximum Weight Capacity: 30 kilograms (66 pounds). Note: Load must be centered.
Minimum Cycle Time: 4 seconds at the maximum pallet size and weight limits.
Lift Above Belt: 68 mm, (not adjustable).
Rotation Increments: 90 degrees (fixed). For 180 degree rotation, two (2) signals must be
sent from the host controller.
Rotation Direction: Clockwise or counterclockwise rotation, direction set by user at installation.
Rotate Drive:
Controller 110 VAC/60Hz or 230 VAC/50 Hz, single phase, 2 amps.
Motor 90 VDC with planetary reducer.
Pneumatic Cylinder: 50 mm Bore x 90 mm Stroke
Compressed Air: 4 to 8 bars, (58 to 116 psi) of clean air.
Air Connections: 8 mm, (5/16") dia. push-lock type plastic tubing.
Host I/O Requirements: (1) output for Rotate Start
(1) output for Pallet Lift
(1) output for Pallet Lower
(1) input for Lift Raised
(1) input for Lift Lowered
(1) input for Rotate Complete
Host Power Requirements: 110 VAC/60Hz or 230 VAC/50 Hz
24 VDC
Technical Data