Owner's manual

13
Installation
WARNING! Do not connect the appliance to the mains until the installation is fully complete.
This extractor hood is intended to be
mounted onto the kitchen wall.
Note: The hood may be installed both with
and without a chimney.
Note: Take into account any special
accessories that are going to be fitted.
• Trace a central line on the wall in order to
ease mounting (1), position the hole
template in a way that the middle line
printed on top corresponds to the central
line marked previously and the lower side
of the mask corresponds to the lower part
of the hood once mounted. (2).
• Make 3 holes Ø 8 mm with a drill and fix
the support bracket with two dowels and
screws to the wall (3), insert the third
dowel into the lower hole.
• Only for chimney installation: Apply the
support bracket „G“ to the adherent
ceiling, use the chimney support bracket
as a hole scheme (if present, the small
eyelet found on the support should
coincide with the line previously traced on
the wall) and trace with a pencil 2 holes,
drill the holes (Ø8mm), insert 2 plugs.
Fasten the support bracket to the wall
with 2 5x45mm screws (4).
G
1
2
3
3
3
4
• Remove the panel and remove the grease
filters (see relevant paragraph).