Installation Manual

DSA E-Series (E2800 60-bay) Table of contents | en 3
Bosch Sicherheitssysteme GmbH Installation manual 2018.02 | V1 | DOC
Table of contents
1
Safety 5
1.1 Safety message explanation 5
1.2 Safety precautions 5
1.3 Important safety instructions 5
1.4 Warning notices 7
1.5 Caution notices 8
1.6 Notices 8
2
Before you begin 10
2.1 Hardware registration 10
2.2 Additional equipment 10
2.3 Additional documentation 10
3
System overview 11
3.1 Device views 11
3.2 LED description 12
3.2.1 LEDs on the operator display panel 12
3.2.2 LEDs on the controller unit 13
3.2.3 LEDs on the I/O modules 15
3.2.4 LEDs on the drives 16
3.2.5 LEDs on the drive drawer 17
3.2.6 LEDs on the power canister 18
3.2.7 LEDs on the fan canister 19
4
Installation 20
4.1 Installing a 60-bay unit 20
4.2 Installing a 60-bay unit with SuperRail 21
4.2.1 Installing SuperRail to square-hole four-post rack 21
4.2.2 Installing SuperRail to round-hole four-post rack 23
4.3 Installing the drives 26
4.4 Installing the front bezel and end caps 26
4.5 Setting the unit ID using the ODP button 27
5
Connection 28
5.1 Connecting the expansion units 28
5.2 Connecting the controller unit to the network 28
5.3 Connecting the controller unit to the management hosts 29
5.4 Connecting the units to the power supply 30
5.5 Supported connections 31
6
Turning on/off AC power 33
6.1 Turning on AC power 33
6.2 Turning off AC power 33
7
Configuring the storage system 34
8
Maintenance 35
8.1 Replacing a drive in a 60-bay unit 35
8.1.1 Preparing to replace a drive 36
8.1.2 Removing a drive 37
8.1.3 Installing a drive 38
8.1.4 After replacing a drive 39
8.2 Replacing a power canister 40
8.2.1 Preparing to remove a power canister 41
8.2.2 Removing a power canister 42