Register your new devic e on MyBosch now and get free b enefits: bosch-h ome.
en Safety Table of contents USER MANUAL 1 Safety .................................................................... 2 2 Avoiding material damage................................... 4 3 Environmental protection and saving energy ....................................................................... 4 4 Operating modes ................................................. 5 5 Familiarising yourself with your appliance ........ 6 6 Basic operation ....................................................
Safety Toxic gases from the flue or the extraction shaft are sucked back into the living space. ▶ Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as a room air-dependent heat-producing appliance is being operated. ▶ It is only possible to safely operate the appliance if the pressure in the room in which the heating appliance is installed does not drop more than 4 Pa (0.04 mbar) below atmospheric pressure.
en Avoiding material damage WARNING ‒ Risk of electric shock! If the appliance or the power cord is damaged, this is dangerous. ▶ Never operate a damaged appliance. ▶ Never pull on the power cord to unplug the appliance. Always unplug the appliance at the mains. ▶ If the appliance or the power cord is damaged, immediately unplug the power cord or switch off the fuse in the fuse box. ▶ Call Customer Service. → Page 8 ▶ Repairs to the appliance should only be carried out by trained specialist staff.
Operating modes Switch the appliance off when you are not using it. ¡ The appliance does not consume any energy. Clean or replace the filters at regular intervals. ¡ The effectiveness of the appliance is increased. Switch off the lighting if you no longer require it. ¡ The lighting does not consume any energy. Put the cooking lid on. ¡ The cooking vapours and condensation are reduced. en 4 Operating modes 4.
en Familiarising yourself with your appliance 5 Familiarising yourself with your appliance 5.1 Controls Switch the appliance on or off The controls are used to configure all functions of your appliance and to obtain information about the operating status. Increase the fan setting Decrease the fan setting Switch the lighting on or off 6 Basic operation 6.1 Switching on the appliance 6.5 Switching off intensive mode 1. Pull out the filter pull-out. 2. Press .
Cleaning and servicing ▶ Do not use hard scouring pads or cleaning sponges. ▶ Do not use any special cleaners for cleaning the appliance while it is hot. ▶ Only use glass cleaners, glass scrapers or stainless steel care products if recommended in the cleaning instructions for the relevant part. ▶ Wash sponge cloths thoroughly before use. en 2. ATTENTION! Falling grease filters may damage the hob below. ▶ Grip below the grease filter with one hand.
en Troubleshooting ▶ Clean the grease filters roughly every 2 months. Requirement: The grease filters have been removed. → "Removing the grease filter", Page 7 1. Observe the information regarding the cleaning agents. → "Cleaning products", Page 6 2. Soak the grease filter in hot soapy water. Use special grease solvent for stubborn dirt. You can obtain grease solvents from after-sales service or the online shop. 3. Use a brush to clean the grease filters. 4. Rinse the grease filters thoroughly. 5.
Accessories The contact details for Customer Service can be found in the enclosed Customer Service directory or on our website. 9.1 Product number (E-Nr.) and production number (FD) en ¡ On top of the appliance. Make a note of your appliance's details and the Customer Service telephone number to find them again quickly. You can find the product number (E-Nr.) and the production number (FD) on the appliance's rating plate.
en Installation instructions 12.1 Included with the appliance After unpacking all parts, check for any damage in transit and completeness of the delivery. Depending on the appliance specifications 12.2 Safety clearances Comply with the safety clearances for the appliance. 12.3 Secure installation Follow these safety instructions when installing the appliance. WARNING ‒ Risk of poisoning! Risk of poisoning from flue gases being drawn back in. Room-air-dependent heat-producing appliances (e.g.
Installation instructions WARNING ‒ Risk of fire! Grease deposits in the grease filter may catch fire. ▶ The specified safety clearances must be complied with in order to prevent a build-up of heat. ▶ Observe the specifications for your cooking appliance. If gas and electric hobs are being operated together, the largest specified clearance applies. ▶ The appliance must be installed with no more than one side directly next to a highsided unit or a wall.
en Installation instructions ¡ Long, rough exhaust air pipes, many pipe bends or small pipe diameters reduce the suction power and increase the fan noise. ¡ An exhaust air pipe that is made of non-combustible material. ¡ To prevent condensate from returning, fit the exhaust air pipe from the appliance with a 1° gradient. Round pipes Use round pipes with an inner diameter of 150 mm (recommended) or at least 120 mm.
Installation instructions 7. Use the enclosed mounting part to mark the fasten- ing points on the inside of the cabinet and use a bradawl to make indentations where the holes are to be. 8. 19 mm wall thickness: Open up the spacers on both of the mounting parts. 9. Screw the mounting parts to the body on the left and right. 10. Remove the limit stops from the bottom of the mounting parts. en Preparing the appliance 1.
en Installation instructions 2. Appliance width 90 cm: Pull the filter pull-out out 2. Shorten the spacers to the required dimension and completely towards the front. Also use two screws each on the left and right to screw the appliance to the side upper cabinets from below. insert them into the slot specified. Removing the appliance 3. Adjust the wall closing strip to the clearance between the appliance and the wall. 1. 2. 3. 4. 5. Cover the hob to prevent damage.
Installation instructions en 7. Push in the fastening bolts using a flat-blade screw- driver and rotate by 90° until the fastening bolts unclip. 8. Push in and turn the fastening bolts gently with your fingers until the fastening bolts springs out of the housing. Lift the appliance slightly and pull on the fastening bolts until the locking mechanism in the cabinet is released. 9. Carefully remove the appliance.
Thank you for buying a Bosch Home Appliance! Register your new device on MyBosch now and profit directly from: • • • • • Expert tips & tricks for your appliance Warranty extension options Discounts for accessories & spare-parts Digital manual and all appliance data at hand Easy access to Bosch Home Appliances Service Free and easy registration – also on mobile phones: www.bosch-home.com/welcome Looking for help? You'll find it here.
